Forum Home Forum Home > Media&User's Review > AMD Motherboards
  New Posts New Posts RSS Feed - B450 Pro4 wont OC RAM
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

B450 Pro4 wont OC RAM

 Post Reply Post Reply
Message Reverse Sort Order
Xaltar View Drop Down
Moderator Group
Moderator Group

Joined: 16 May 2015
Status: Online
Points: 5445
Post Options Post Options   Thanks (0) Thanks(0)   Quote Xaltar Quote  Post ReplyReply Direct Link To This Post Topic: B450 Pro4 wont OC RAM
    Posted: 27 Mar 2019 at 1:08am
Install your RAM in A2 and B2 slots, if you are only using the A slots then you are not running in dual channel and will have a harder time overclocking your RAM. A2 and B2 are the preferred slots for a 2 module setup. Make sure your RAM is installed in the correct slots then try load XMP again and see if that gets you up and running. If not, load XMP then manually load a lower speed (2933) and try that, repeat (lowering the frequency) until you can post and pass stress testing on your RAM.

You can also use the Ryzen calculator as Tanaka007 suggested but this is a much more involved process. You can use the guides he posted if you feel up to the challenge, I am not going to repeat information already available on the guides here

Edited by Xaltar - 27 Mar 2019 at 1:09am
Back to Top
tanaka007 View Drop Down

Joined: 26 Mar 2019
Location: Japan
Status: Offline
Points: 1
Post Options Post Options   Thanks (0) Thanks(0)   Quote tanaka007 Quote  Post ReplyReply Direct Link To This Post Posted: 26 Mar 2019 at 11:44pm
First check sure your motherboard is T-topology or Daisy Chain.
T-topology is limited to 3466 MHz (average). The Daisy chain has a limit of 3733 MHz (average).
The limit clocks of T-topology and Daisy chain are very different.
Use the Ryzen DRAM Calculator if necessary.
If you want to use really very fast RAM you should use ASUS PRIME X470-Pro etc...

https: //

https: //
https: //
Back to Top
wingnutt92 View Drop Down

Joined: 14 Mar 2019
Status: Offline
Points: 3
Post Options Post Options   Thanks (0) Thanks(0)   Quote wingnutt92 Quote  Post ReplyReply Direct Link To This Post Posted: 14 Mar 2019 at 11:43pm
Hi. New build, specs as follows:

ASRock B450 Pro4
AMD Ryzen 5 2600X
Team - Vulcan 16 GB (2 x 8 GB) DDR4-3000 Memory Model: TLRED416G3000HC16CDC01
Intel - 660p Series 1 TB M.2-2280 Solid State Drive
AMD Radeon RX580

RAM modules installed in the A.1/A.2 DIMMS. I've updated my Bios to current (1.80). When I attempt to enable the XMP profile to overclock my RAM to DDR4-3000 speed the system fails to boot 2 times and then reverts back to the auto speed of DDR4-2400.

The XMP profile appears to be loading the correct timings of 16-18-18-38 and voltage of 1.35v for the RAM.

Help? As i said, the RAM is new, i don't mind exchanging it for something comparable if there isn't a simple fix.

Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.06
Copyright ©2001-2018 Web Wiz Ltd.

This page was generated in 0.047 seconds.