https://forum.asrock.com/ Copyright (c) 2006-2013 Web Wiz Forums - All Rights Reserved. Sun, 05 Apr 2026 11:26:08 +0000 Wed, 08 Jul 2020 16:07:23 +0000 http://blogs.law.harvard.edu/tech/rss Web Wiz Forums 12.04 360 https://forum.asrock.com/RSS_post_feed.asp?TID=14854 https://forum.asrock.com/forum_images/web_wiz_forums_black.png https://forum.asrock.com/ https://forum.asrock.com/forum_posts.asp?TID=14854&PID=77094&title=hand-me-down-extreme-4-wont-post#77094 Author: Xaltar
Subject: 14854
Posted: 08 Jul 2020 at 4:07pm

The 5820 should be supported on all BIOS versions so BIOS versions shouldn't be
the issue. Have you connected the 8pin CPU power to the board? I am guessing yes
as you get beeps with no RAM but always worth mentioning.

As ASRock TSD stated, clear CMOS, it could simply be a case of corrupted/invalid
memory settings left over from the last system the board was in. If you have the
option, also try with another GPU on the off chance you are simply not getting
a video signal. Most modern boards do not have POST beep enabled by default, this
means the system could be POSTing and you just don't know because the display
isn't getting a signal. If you don't have another GPU to test with, try with
different display cables/outputs.]]> Wed, 08 Jul 2020 16:07:23 +0000 https://forum.asrock.com/forum_posts.asp?TID=14854&PID=77094&title=hand-me-down-extreme-4-wont-post#77094 https://forum.asrock.com/forum_posts.asp?TID=14854&PID=77088&title=hand-me-down-extreme-4-wont-post#77088 Author: ASRock_TSD
Subject: 14854
Posted: 08 Jul 2020 at 2:33pm

Dear ShayBlez,

Thanks for posting.

Regarding your question about the system will not post, kindly try to reinstall the CPU and RAM to different slots to see if it will work.

Also, please refer to the page.8 #14 from the link below to press the CMOS button for more than 3 seconds after the power is removed.

https://download.asrock.com/Manual/X99%20Extreme4.pdf

With thanks,
ASRock TSD]]> Wed, 08 Jul 2020 14:33:16 +0000 https://forum.asrock.com/forum_posts.asp?TID=14854&PID=77088&title=hand-me-down-extreme-4-wont-post#77088 https://forum.asrock.com/forum_posts.asp?TID=14854&PID=76982&title=hand-me-down-extreme-4-wont-post#76982 Author: ShayBlez
Subject: 14854
Posted: 04 Jul 2020 at 10:57am

Hello! The past few weeks have been a train of troubleshooting a motherboard I was gifted, I have yet to get it to post, to be clear this is the board I have:

https://www.asrock.com/mb/Intel/X99%20Extreme4/

Its symptoms are a stuck on post led above Bios 1, no post beep codes, you can hear it only clicks somewhat when powered up with ram inserted in any slot, however, does beep 3 long with no ram at all. I thought the CPU was good based upon that, a 5820k.

When I got the board I was given a some adata chips that aren't quite on the QVL and thought those must be the problem since it beeps without ram installed, but I went and picked up some Corsair RGB vengeance ram today to the same symptom of stuck post led and no beeps, as I had gotten with the previous chips it came with in the first place.

I realize I likely have no serviceability through ASRock to repair it but wanted to know if there was anyone that could think of something I haven't yet.

I've triple checked the CPUs laid in socket well, cooler installed properly (Mugen scythe rev b for clearance of the ram sockets) and tried either new and old single dimm boot in every slot, getting me nowhere different each time.

PSU is a corsair rm1000i

Again, any help is appreciated, will give more info on my build if asked.


]]> Sat, 04 Jul 2020 10:57:37 +0000 https://forum.asrock.com/forum_posts.asp?TID=14854&PID=76982&title=hand-me-down-extreme-4-wont-post#76982