https://forum.asrock.com/ Copyright (c) 2006-2013 Web Wiz Forums - All Rights Reserved. Wed, 08 Apr 2026 13:51:27 +0000 Sat, 12 Jun 2021 10:32:18 +0000 http://blogs.law.harvard.edu/tech/rss Web Wiz Forums 12.04 360 https://forum.asrock.com/RSS_post_feed.asp?TID=19042 https://forum.asrock.com/forum_images/web_wiz_forums_black.png https://forum.asrock.com/ https://forum.asrock.com/forum_posts.asp?TID=19042&PID=87641&title=helppppp#87641 Author: ket
Subject: 19042
Posted: 12 Jun 2021 at 10:32am

What are your full system specs? GeIL have several Orion kits of varying speeds for one thing, I'd hazard a guess your memory is using Hynix CJR or DJR ICs but you can check this with Thaiphoon Burner. The first thing I'd do is go into the UEFI, load setup defaults, save and exit. Enter UEFI again, load the XMP profile, disable Gear Down and set Command Rate to 2T, also change tCKE to 8, now save and exit. Also what DIMM banks do you have the memory installed in? A picture of your system with the side panel off would help quite a bit. Its worth downloading and running HWinfo64 as well to check system temperatures.]]> Sat, 12 Jun 2021 10:32:18 +0000 https://forum.asrock.com/forum_posts.asp?TID=19042&PID=87641&title=helppppp#87641 https://forum.asrock.com/forum_posts.asp?TID=19042&PID=87590&title=helppppp#87590 Author: Xaltar
Subject: 19042
Posted: 09 Jun 2021 at 5:14am

It sounds like your RAM isn't properly compatible with your board. Try running in
dual channel with XMP disabled and see if it is stable @2133. If so then it is
likely the RAM isn't happy with it's XMP setting on your board/CPU combo. If this
is the case then you can try loading XMP (with dual channel) and manually lower the
frequency to the next speed down. Repeat if unstable until you are stable.

You can also try looking up a tutorial on manually setting your RAM speed and
settings using Ryzen Calc. Google Ryzen Calculator and you should find plenty of
guides.]]> Wed, 09 Jun 2021 05:14:31 +0000 https://forum.asrock.com/forum_posts.asp?TID=19042&PID=87590&title=helppppp#87590 https://forum.asrock.com/forum_posts.asp?TID=19042&PID=87585&title=helppppp#87585 Author: Ahoy
Subject: 19042
Posted: 08 Jun 2021 at 10:58pm

Hello, i have problem with my stuff :
Asrock A320M HDV R4.0
Ryzen 5 3400G
Geil Orion 8GB x 2

when i open blender and heavy task my PC start flicking a sec and then error msg appear like in photo(we detected a driver timeout has occurred on your system). this crash only happened when i use dual channel ram, but when i use single ram this problem never happen.

I already installed recommended amd driver and motherboard chipset driver but still crash

Any Solution?]]> Tue, 08 Jun 2021 22:58:37 +0000 https://forum.asrock.com/forum_posts.asp?TID=19042&PID=87585&title=helppppp#87585