ASRock.com Homepage
Forum Home Forum Home > Technical Support > Intel Motherboards
  New Posts New Posts RSS Feed - ASRock Z690 Pro Rs not turning on after clearing c
  FAQ FAQ  Forum Search Search  Events   Register Register  Login Login

ASRock Z690 Pro Rs not turning on after clearing c

 Post Reply Post Reply
Author
Message
Logjan View Drop Down
Newbie
Newbie
Avatar

Joined: 05 Dec 2022
Location: New York
Status: Offline
Points: 35
Post Options Post Options   Thanks (0) Thanks(0)   Quote Logjan Quote  Post ReplyReply Direct Link To This Post Topic: ASRock Z690 Pro Rs not turning on after clearing c
    Posted: 05 Dec 2022 at 9:07pm
Yesterday I was having issues with my motherboard and XMP not booting so I decided to clear the cmos. When I did that however the motherboard stopped turning on and the only life it shows are the rgb leds. I tried the bios flashback, reseating all connections and cpu but still nothing. Is there anything I could do?
Back to Top
Xaltar View Drop Down
Moderator Group
Moderator Group
Avatar

Joined: 16 May 2015
Location: Europe
Status: Offline
Points: 17138
Post Options Post Options   Thanks (0) Thanks(0)   Quote Xaltar Quote  Post ReplyReply Direct Link To This Post Posted: 06 Dec 2022 at 3:12am
Make sure the clear CMOS jumper is in the correct position. If it is set in the
"clear" position the board will not allow you to power it on.

If the clear CMOS jumper is not the issue then try disconnecting power from the
wall, pull the CMOS battery then press and hold the power button for a few seconds.
Leave the system like this for an hour then put the battery back in and atempt
to power on again.

If neither of those help then try contacting ASRock directly here:
https://event.asrock.com/tsd.asp

Good luck.
Back to Top
Logjan View Drop Down
Newbie
Newbie
Avatar

Joined: 05 Dec 2022
Location: New York
Status: Offline
Points: 35
Post Options Post Options   Thanks (0) Thanks(0)   Quote Logjan Quote  Post ReplyReply Direct Link To This Post Posted: 06 Dec 2022 at 5:08am
Thanks for responding.
I don?t have a cmos jumper installed so I just removed the battery and unplugged power. I?ll let it sit for a few hours to see if that fixes anything
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.04
Copyright ©2001-2021 Web Wiz Ltd.

This page was generated in 0.078 seconds.