Double SSD heat sink - protective film removal |
Post Reply |
Author | |
PapaFrito
Newbie Joined: 16 Oct 2024 Status: Offline Points: 170 |
Post Options
Thanks(0)
Posted: 31 Oct 2024 at 2:43am |
Hi,
I've got B650 Steel Legend Wifi board: https://www.asrock.com/MB/AMD/B650%20Steel%20Legend%20WiFi/index.asp#Overview I'm currently assembling the rig. I bought a single SSD NVMe and I want to install it in one of the two Gen 4 slots, which are covered by a single heat shield. It comes with 2 thermal pads, one for each SSDs. Both are covered with a plastic strip (protective film) which has to be removed. The question is - Am I supposed to remove both protective films if I'm currently going to install and use only one SSD? The information is nowhere to be found except that the manual describes each slot installation separately but says "protective films" in plural. |
|
PapaFrito
Newbie Joined: 16 Oct 2024 Status: Offline Points: 170 |
Post Options
Thanks(0)
|
Ended up leaving the protective film on the other pad...
|
|
NDRE28
Groupie Joined: 08 Sep 2024 Location: Romania Status: Offline Points: 435 |
Post Options
Thanks(0)
|
Hello! That's the correct decision. |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |