B650E PG Riptide USB error 43

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   I have a question regarding the Asrock B650E PG Riptide WiFi, but first a few trifle:
1) How can I make sure that when I turn on the fans, they don't howl at 100% for a few seconds? I'm not turning on a vacuum cleaner, after all.
2) Why is a successful BSOD run accompanied by one long beep and not one short one like everyone else?
Ok, now a question:
After turning on the PC and after some (inconstant) time, there is a sound of the device being disconnected and in the  manager, one of the USB controllers is disconnected with error 43. After rebooting, it starts working again. What could it be?

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Antis Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 10 Jul 2024 Status: Offline Points: 15	Post Options Post Reply Quote Antis Report Post Thanks(0) Quote Reply Topic: B650E PG Riptide USB error 43 Posted: 7 hours 41 minutes ago at 8:06pm
	I have a question regarding the Asrock B650E PG Riptide WiFi, but first a few trifle: 1) How can I make sure that when I turn on the fans, they don't howl at 100% for a few seconds? I'm not turning on a vacuum cleaner, after all. 2) Why is a successful BSOD run accompanied by one long beep and not one short one like everyone else? Ok, now a question: After turning on the PC and after some (inconstant) time, there is a sound of the device being disconnected and in the manager, one of the USB controllers is disconnected with error 43. After rebooting, it starts working again. What could it be?

Xaltar Members Profile Send Private Message Find Members Posts Add to Buddy List Moderator Group Joined: 16 May 2015 Location: Europe Status: Offline Points: 27023	Post Options Post Reply Quote Xaltar Report Post Thanks(0) Quote Reply Posted: 4 hours 6 minutes ago at 11:41pm
	As far as I am aware there is no way to control the fans until the BIOS initializes the controllers have no input until this happens and thus the fans operate at 100% until the controller receives a command to lower the speed. For the beep, try disconnecting your keyboard and powering on. If the long beep is gone then you may have a stuck key, if not then make sure your RAM is properly inserted into slot B2 (if a single stick) or slots A2 and B2 (for 2 modules). As for the USB, I am not sure, I have not encountered the issue myself. You can try disconnecting all USB devices other than keyboard and mouse and test if the issue persists. I have seen quite a few USB peripherals cause conflicts and issues with the USB controllers on various systems.