New build - not powering up
Printed From: ASRock.com
Category: Technical Support
Forum Name: Intel Motherboards
Forum Description: Question about ASRock Intel Motherboards
URL: https://forum.asrock.com/forum_posts.asp?TID=10596
Printed Date: 20 May 2024 at 11:12pm
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: New build - not powering up
Posted By: golfcart22
Subject: New build - not powering up
Date Posted: 03 Jan 2019 at 1:05pm
|
Z390 Taichi Ultimate Motherboard i9-9900k cpu Corsair H100i cooler TridentZ DDR4-4000 memory (4 sticks 8gig - model on supported list) OCZ 900w power supply HELP! Just swapped swapped out a working i7-4790 MB/CPU/RAM with the setup above and nothing will post or power on. I see NO numbers on the debug display. The only thing I see the the bright white light in the center of the board going on and off. Yes, the video card (1080TI) is connected and powered. I have tried the following... 1 stick of ram only in slot A1 unplugged all sata connectors re-seated the CPU all fans includeing CPU are connected to power Yes - 4/8 pin cpu power cable from the PSU is connected to the MB. Really at my wits end and need some help. Anyone have any ideas or need more information from me first? Please help, Tony |
Replies:
Posted By: RLGL
Date Posted: 03 Jan 2019 at 11:44pm
|
Any fans trying to turn, even briefly? PS Fan running ? Use a DVM to verify voltages are present when PS is powered up, use the paperclip test; https://www.wikihow.com/Check-a-Power-Supply ------------- Asrock Z370 Gaming K6,Intel i7 8700K, Asrock x570 Taichi |
Posted By: Xaltar
Date Posted: 04 Jan 2019 at 12:12am
|
Double check all your connections, paying particular attention to your front panel connectors. Check the Clear CMOS jumper and make sure is isn't set to clear and if all else fails, pull the board from the case and make sure there were no shorts under the board. While you have it out, test it outside the case. Good luck  ------------- 
|
Posted By: golfcart22
Date Posted: 04 Jan 2019 at 12:19am
| Thanks for the tips and will try this later after I return home from work and report back. |
Posted By: golfcart22
Date Posted: 05 Jan 2019 at 2:08pm
|
Turns out I had a bad PSU. <case closed> Have another question but didnt want to open another thread - can someone please tell me where the second USB 2.0 port is located on this Motherboard? The manual and spec state there are two - yet I can only find one ? Thanks Tony |
Posted By: RLGL
Date Posted: 05 Jan 2019 at 10:46pm
|
They should be next to each other , to the left of Dr Drbug display ------------- Asrock Z370 Gaming K6,Intel i7 8700K, Asrock x570 Taichi |
Posted By: golfcart22
Date Posted: 09 Jan 2019 at 12:17am
|
Still have yet to find it but I fixed my issue by adding an internal 2.0 ISB hub from NZXT. Thanks everyone - have a new issue with RAM but will start a new thread. Tony |