Hyper Quad M.2 Card Performance?
Printed From: ASRock.com
Category: Technical Support
Forum Name: AMD Motherboards
Forum Description: Question about ASRock AMD motherboards
URL: https://forum.asrock.com/forum_posts.asp?TID=13766
Printed Date: 08 Aug 2025 at 5:28pm
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: Hyper Quad M.2 Card Performance?
Posted By: bvalente
Subject: Hyper Quad M.2 Card Performance?
Date Posted: 02 Mar 2020 at 11:03am
|
It seems my hyper quad m2 raid array is pretty slow? seq read 4747 seq write 6115 (as measured by crystaldiskmark) https://www.dropbox.com/s/sgqamkrc86zii97/crystaldisk.png?dl=0 this is 4x 1tb Intel 660p M2 cards in a raid 0 configuration I have seen specs of similar setups that are 115304 seq read doesn't have to match, but seems like it could be much faster? I'm pretty sure I have the firmware configured correctly, the card is in slot 3. the swap disks i have set up on the raid array are a constraint to performance on some of my most important apps Any feedback, suggestions, questions would be great thank you! Brian |
Replies:
Posted By: cx5
Date Posted: 02 Mar 2020 at 3:06pm
|
Hello Brian, seq read 4747ï¼?sounds too low, should be this link multiply 4 = 7000Mb/s https://cdn.mos.cms.futurecdn.net/zY4mMsbYdA4JUC3ayDKGUm-970-80.png seq write 6115, sounds about right to me, because 660p is slow, only around 1700mb/s, https://cdn.mos.cms.futurecdn.net/FRZi4HbetMXCawprZFMsab-970-80.png so 4 card is 7000. If you get a HP EX950, write is 2900Mb/s then 4 card raid-0 is around 11000Mb/s those guys with very high transfer are using very fast NVMe like HP EX950 ------------- x370taichi@3.50gen4 AX750 Optane900P SN770 3800x PosdonZro4 BarrowPWM-17w>420x140x28 XFX SWFT319 6900XT MSI RX560 LP to get Fluid Motion BlueskyFRC 75hz |
Posted By: gizmic
Date Posted: 02 Mar 2020 at 6:21pm
|
actually quad raid 0 are closer to 3X performance ------------- 
|
Posted By: bvalente
Date Posted: 02 Mar 2020 at 11:48pm
|
Thanks - is that 3x performance of? Brian |
Posted By: stonewater
Date Posted: 03 Apr 2020 at 12:47am
|
So I just tried installing 4 x Seagate Firecuda 520's in RAID 0 on the Hyper Quad and I'm getting writes topping out at 3.89GBps and reads at 5.22GB/s which looks suspiciously to me like PCI4. This is on a TRX40 Taichi which comes with the hyper quad - in the ASrock recommended PCIE4. Did anyone else experience this / solve this? Thanks David |
Posted By: stonewater
Date Posted: 03 Apr 2020 at 12:48am
| Of course I meant 'suspiciously like PCI3'. |