AMD Motherboards - Polychrome paired with NX800 Tower

Print Page | Close Window

Polychrome paired with NX800 Tower

Printed From: ASRock.com
Category: Technical Support
Forum Name: AMD Motherboards
Forum Description: Question about ASRock AMD motherboards
URL: https://forum.asrock.com/forum_posts.asp?TID=14554
Printed Date: 04 Dec 2024 at 1:32am
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com

Topic: Polychrome paired with NX800 Tower

Posted By: GottesSchaf
Subject: Polychrome paired with NX800 Tower
Date Posted: 02 Jun 2020 at 7:31am

Hey guys,
so basically I can't get the ARGB to work for my [URL=https://www.antec.com/product/case/nx800.php]Antec NX800 Tower[/URL] (I don't know if I'm allowed to post this link so you're free to change it if I'm not).
I got a x570 Steel Legend and the Antec NX800 Tower. I plugged the ARGB 3 pin from my Tower into the ADDR_LED1 3 pin connector on my Motherboard, but Polychrome doesn't want to change any colors of my fans.
As a side note, before I switched to AMD/x570 I had a MSI Z390 Tomahawk with a i7-9700k and with MSI's Mystic Light it worked perfectly fine(it is uninstalled).

The 3 pin feels kinda 'loose' on the ADDR_LED1 connector, so I don't know if this is an issue.
I downloaded the Polychrome version from here: [URL=https://www.asrock.com/mb/AMD/X570%20Steel%20Legend/index.asp#Download]Click[/URL]
My RGB of the Shields on the Motherboard are changing colors normally when I address them new ones with Polychrome.

I hope you guys can help me here.

Replies:

Posted By: GottesSchaf
Date Posted: 03 Jun 2020 at 8:11am

No one..?

Posted By: ThreeDee
Date Posted: 03 Jun 2020 at 11:05am

According to this:
https://www.antec.com/documents/product/case-NX800_Control_190816_OUTLINE.pdf

says to press the LED button for 3-6 seconds and wait for white light to blink twice and then it will change to motherboard sync mode .. if it still doesn't sync, then try flipping the connector around 180 and plug it back in and try motherboard sync mode again.

Posted By: GottesSchaf
Date Posted: 04 Jun 2020 at 2:13am

ThreeDee wrote:

According to this:
https://www.antec.com/documents/product/case-NX800_Control_190816_OUTLINE.pdf

says to press the LED button for 3-6 seconds and wait for white light to blink twice and then it will change to motherboard sync mode .. if it still doesn't sync, then try flipping the connector around 180 and plug it back in and try motherboard sync mode again.

duh... Vollkommen den kleinen Zettel vergessen... Vielen Dank!