New Asrock J5040 doesn't boot or beep
Printed From: ASRock.com
Category: Technical Support
Forum Name: Intel Motherboards
Forum Description: Question about ASRock Intel Motherboards
URL: https://forum.asrock.com/forum_posts.asp?TID=18001
Printed Date: 12 Dec 2024 at 8:02am
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: New Asrock J5040 doesn't boot or beep
Posted By: adri.foschi
Subject: New Asrock J5040 doesn't boot or beep
Date Posted: 03 Feb 2021 at 9:11pm
|
Hello, I'm building a mini pc using: - Asrock j5040 itx motherboard - Antec ISK 110 itx case 90w - Crucial 8gb ddr4 RAM CT8G4SFS824A I connected power ram, btn, leds, hdaudio, usb and hdmi. The led power on but no output on hdmi port. I tried to remove the ram but it doesn't beep or anything. It seems died. I tried to clear CMOS too but without success. What happens? Thanks you |
Replies:
Posted By: adri.foschi
Date Posted: 04 Feb 2021 at 4:30am
|
Update: tried with vga cable, tried with only one ram, tried with another psu. Same behavior :( |
Posted By: BeCube
Date Posted: 04 Feb 2021 at 4:36am
Same here  The RAM are listed official with "compatible"... |
Posted By: RPI8GB
Date Posted: 09 Feb 2021 at 9:48pm
| Same issue here with crucial.. just resolved with patriot (PSD48G240081S) |
Posted By: Will_BC
Date Posted: 03 Dec 2024 at 7:53am
|
Hey did you guys ever figure out a solution? My old board Asrock Q1900 (Celeron J1900 embedded) died so I ordered the J5040 from Amazon with Patriot 16GB (2x8GB) DDR4-3200 (shows as DDR4 2400 in BIOS). When it boots and I go into BIOS, i can see the USB flash drive and SATA drives. The SATA drives are not shown as a boot option though. And when I try to boot (default or override) from USB flash drive, it freezes (clock on bottom right even stops). |