X299 Steel Legend M2 Issue
Printed From: ASRock.com
Category: Technical Support
Forum Name: Intel Motherboards
Forum Description: Question about ASRock Intel Motherboards
URL: https://forum.asrock.com/forum_posts.asp?TID=19566
Printed Date: 08 May 2024 at 9:51am Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: X299 Steel Legend M2 Issue
Posted By: jdscogin
Subject: X299 Steel Legend M2 Issue
Date Posted: 16 Sep 2021 at 7:28am
I was able to install the M.2 on the short side of the U. But when I try to take the other side off, it does not seem to come up. It's the part that has the "Steel Legend" logo that lights up. I tried pulling on it pretty hard, and it did not budge. I need someone that has installed the second M.2 to tell me if I should pull harder.
------------- JD Scogin
|
Replies:
Posted By: The_Nephilim
Date Posted: 16 Sep 2021 at 8:08am
well it should be on an angle when inserting it and removing it and it should not be too hard to pull it out..
perhaps you inserted it wrong?
|
Posted By: jdscogin
Date Posted: 16 Sep 2021 at 8:16am
I am sorry, I guess I did not explain it too well. It's not the SSD I can't remove. It is the heat sink cover.
------------- JD Scogin
|
Posted By: The_Nephilim
Date Posted: 16 Sep 2021 at 12:36pm
Well you might have put it on the wrong way or a clip is holding it or something.. I would be carefull
|
Posted By: jdscogin
Date Posted: 16 Sep 2021 at 9:34pm
I talked to a friend and he said that it looked like there were 3 screws holding the heatsink. Maybe there is a screw that is covered by the label? Hmmm So when I got up this morning, I took the computer apart again and looked at the heatsink cover. There was absolutely no screw covered up. So I put my fingers behind the heatsink where it shows a screw might be. I did find something sticking up from the motherboard to the heatsink cover. I put a finger on both sides of it a pulled a little. The heatsink cover popped right off. The SSD is installed and I now have 2 TB in my new computer. I can see now what the drawing was trying to say. Not obvious at all. There should be a note in the book that explains that better. Anyway, issue solved. I hope anyone else with this issue will read this and save them a lot of time and anguish. Thanks for all who replied.
------------- JD Scogin
|
|