MAC addresses are invalid in both CMOS and Flash
Printed From: ASRock.com
Category: Technical Support
Forum Name: Intel Motherboards
Forum Description: Question about ASRock Intel Motherboards
URL: https://forum.asrock.com/forum_posts.asp?TID=2005
Printed Date: 07 Aug 2025 at 11:24pm
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: MAC addresses are invalid in both CMOS and Flash
Posted By: Parsix
Subject: MAC addresses are invalid in both CMOS and Flash
Date Posted: 15 Feb 2016 at 6:18pm
|
Hi i have Asrock G41M-VS3 V2.00 In POST I get the following message and Just press the F1 key can be passed: MAC addresses are invalid in both CMOS and Flash Lan ID Chip: AR8152 ------------------------------------------------------------------------------------------------- i tried by last version of MACTOOL but not worked(Recive : NOT SUPPORTED) i tried this command with MacTool in DOS: MAC C [MACID] and MACU C [MACID] and i tried by last version of AFUDOS v4 and AFUWIN v4.48 but not worked(Recive : NOT SUPPORTED) i tried this command with AFUDOS in DOS: afudos /M[MACID] i tried this command with AFUWIN in WINDOWS-CMD: afuWIN /M[MACID] |
Replies:
Posted By: wardog
Date Posted: 15 Feb 2016 at 7:48pm
|
I believe this is what you're looking for to use for the AR8152. I say believe as I don't see the AR8152 specifically in either tool. But give 'em a try if they ar newer version(s) that you have there now. MAC Tool v1.17f and 1.61b http://www.asrock.com/support/Download/MacTool.asp" rel="nofollow - http://www.asrock.com/support/Download/MacTool.asp On the off chance neither works you'll need to contact ASRock Technical Support http://event.asrock.com/tsd.asp" rel="nofollow - HERE |
Posted By: Parsix
Date Posted: 15 Feb 2016 at 8:19pm
|
I've tested both versions but does not work http://event.asrock.com/tsd.asp Last week I got two requests sent but not received an answer |
Posted By: Xaltar
Date Posted: 15 Feb 2016 at 8:51pm
|
ASRock was on holiday last week owing to Chinese New Year. They are back this week however, I am sure they will get back to you as soon as possible. Bare in mind they will have to deal with a backlog of support requests however. ------------- 
|
Posted By: Parsix
Date Posted: 16 Feb 2016 at 6:40pm
|
MAC Tool v1.17f work fine! |
Posted By: jonano
Date Posted: 13 May 2018 at 3:17am
| " rel="nofollow - The MAC Tool is only available for Microsoft Based platform ? Not for ETHOS or Unbuntu or Linux ? Because I am mining ethereum with BTC PRO H110 and I have this same problem and I need this tool as soon as possible. Because I cant reboot automatically I always need to press F1. If I could disable this F1 somewhere it would be nice. |