H510 Pro BTC+ GPU Issues
Printed From: ASRock.com
Category: Technical Support
Forum Name: Intel Motherboards
Forum Description: Question about ASRock Intel Motherboards
URL: https://forum.asrock.com/forum_posts.asp?TID=21090
Printed Date: 27 Apr 2024 at 8:07am
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: H510 Pro BTC+ GPU Issues
Posted By: Tai-Pan
Subject: H510 Pro BTC+ GPU Issues
Date Posted: 12 Jan 2022 at 12:19pm
* If I install GPUs in PCEI3, 4, 5 and 6 everything work as it should.
* If I also install a GPU in PCIE2 the system enters in the Bios and the only way to boot up is by manually going to EXIT -> Choosing the Manual SATA partition to boot from. It basically stops booting up automatically... No errors.
* If I also install a GPU in PCIE1 the BIOS beeps 8 times (Display memory error) and halts
* If I tried to install my 6 GPU in the USB Riser, nor the Bios or the Windows Device Manager shows the card installed.
---
This happens in two different H510 motherboards, using GPU 6900XT, 2 and/or 3 1600W PSU and the bios updated to the latest version available 1.4
Did anybody run into similar issues, any solutions/workarounds that you found? I tried setting the PCIes to GEN2, and plenty of other Bios setting, and no solutions so far...
ANY GOOD ADVICE IS MORE THAN WELCOME AT THIS POINT! THANKS
|
Replies:
Posted By: threadzipper1957
Date Posted: 16 Mar 2022 at 12:12am
Dear Tai-Pan
Some graphics cards, have a problem with Clever Access memory (CAM)
Always set CSM to disabled, and Above 4 G Decoding to enabled.
Try disabling CAM, and check for the latest BIOS
Also check all slots individually with only 1 card, to verify, they are working
-------------
Kind Regards
|
|