X-570 Taichi w/ AMD 5600G
Printed From: ASRock.com
Category: Technical Support
Forum Name: AMD Motherboards
Forum Description: Question about ASRock AMD motherboards
URL: https://forum.asrock.com/forum_posts.asp?TID=23564
Printed Date: 03 May 2024 at 8:19am
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: X-570 Taichi w/ AMD 5600G
Posted By: bevthornton
Subject: X-570 Taichi w/ AMD 5600G
Date Posted: 21 May 2022 at 9:30pm
I have an X-570 Taichi with 5600G CPU installed. BIOS was updated by flashback direct from as shipped to 4.80, non-incremental. No video signal is going out the HDMI on the board. Dr. Debug shows 00, manual doesn't mention what that means. Cable and monitor were checked on another machine and work fine. Motherboard lights up, fans spin, just no video signal out the HDMI port.
What does Dr Debug display 00 mean?
Should I redo the updates in incremental order?
What are other possibilities for no video signal?
How would I be able to tell if the problem was the board or the CPU?
|
Replies:
Posted By: MadScientist
Date Posted: 21 May 2022 at 9:48pm
Code 00 Please check if the CPU is installed correctly and then clear CMOS.
Check your CPU for bent pins.
|
Posted By: bevthornton
Date Posted: 22 May 2022 at 1:34am
|
Checked the CPU, no bent pins, orientation correct. Held in Clear CMOS buttons for 30 seconds each. Still the same, no video detected by the monitor. I'll try re-doing the flashback update.
|
Posted By: bevthornton
Date Posted: 31 May 2022 at 1:23am
Turned out to be a faulty 8-pin CPU power cable.
With all the RGB on the board, maybe it would have been a good idea to use a few as power or connection indicators. Dr Debug doesn't do it.
|
|