No POST when remapping Optane 800P, W480
Printed From: ASRock.com
Category: Technical Support
Forum Name: Intel Motherboards
Forum Description: Question about ASRock Intel Motherboards
URL: https://forum.asrock.com/forum_posts.asp?TID=24690
Printed Date: 22 Jul 2025 at 9:20am
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: No POST when remapping Optane 800P, W480
Posted By: Dtaibi
Subject: No POST when remapping Optane 800P, W480
Date Posted: 01 Jul 2022 at 1:13am
Hello, I need help with the same situation. I have the W480 Creator MoBo, I have the optane 800P card inserted in M2_3. The documentation says that all three M2 slots on the W480 Board support optane, however under the UEFI EZ Mode main screen, M2_3 shows N/A. When I switch to Advanced mode -> Advanced -> Storage Configuration, M2_1, which is my Samsung 980 boot drive, and M2_3 show up for the option to remap. However when I enable the Teton Glacier mode AND enable remapping of the M2_3 optane drive, the board never boots and just continues to power cycle until the UEFI is reset to defaults. I have updated the W80 UEFI to the latest 1.50 firmware.
Please assist me as I would very much like to use this Optane 800P chip that I purchased!
|
Replies:
Posted By: threadzipper1957
Date Posted: 13 Jul 2022 at 8:22pm
Dear Dtaibi,
I think it would be best to use the tech support form
https://event.asrock.com/tsd.asp" rel="nofollow - https://event.asrock.com/tsd.asp
It is possible to make BIOS screenshots, using a FAT formatted USB stick, just press F12 to make a screenshot.
The information in the support form, will help to diagnose the problem.
When using a gmail account, check the spam folder for a reply
-------------
Kind Regards
|
|