x370 Taichi RAM problems after 5800x3d upgrade
Printed From: ASRock.com
Category: Technical Support
Forum Name: AMD Motherboards
Forum Description: Question about ASRock AMD motherboards
URL: https://forum.asrock.com/forum_posts.asp?TID=26015
Printed Date: 04 Nov 2025 at 10:23pm
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: x370 Taichi RAM problems after 5800x3d upgrade
Posted By: ImLost
Subject: x370 Taichi RAM problems after 5800x3d upgrade
Date Posted: 14 Jun 2023 at 11:26pm
When going from my 3600x to the 5800x3d I updated my bios to 7.00 then 7.10 as per the taichi instructions loading default uefi after each update. However, now when dual channel RAM is installed in either configuration the PC will power cycle with the monitors and debug LED remaining blank. With one stick of RAM in either the A1 or B1 slot the PC will boot and work as intended. I thought it was a bad memory controller on the CPU so I returned it for a new one but the same problem persists. Oh and I also tried the full CMOS reset process by no dice there as well.
Any suggestions on what I could try next would be much appreciated.
|
Replies:
Posted By: cx5
Date Posted: 16 Jun 2023 at 11:34am
may be some information here might be of use
https://www.overclock.net/threads/asrock-x370-taichi-overclocking-thread.1627407/page-520" rel="nofollow - https://www.overclock.net/threads/asrock-x370-taichi-overclocking-thread.1627407/page-520
-------------
x370taichi@3.50gen4
AX750 Optane900P SN770
3800x PosdonZro4 BarrowPWM-17w>420x140x28
XFX SWFT319 6900XT
MSI RX560 LP to get Fluid Motion BlueskyFRC 75hz
|
Posted By: ImLost
Date Posted: 16 Jun 2023 at 10:57pm
Tried his voltage advice by no luck, I wonder if it's just the RAM in general being the problem.
Corsair Vengeance LPX 32GB 3600 (PC4-28800) C18 1.35V
SKU - CMK32GX4M2D3600C18
|
|