I have x570 Taichi and 5950x with 1 x nvme with Windows 11 on it, and 2 x matching nvme that I would like to use as RAID0. I'm hoping there is a way to do this without installing windows again, but none of the guides show how to install the drivers post installation.
So far I have followed these instructions:
While the system is booting, press [F2] or [Del] key to enter UEFI setup utility.
2. Go to Advanced\Storage Configuration.
3. Set ?œSATA Controller(s)??to <RAID>.
4. Go to Advanced\AMD PBS and set ?œNVMe RAID mode??to <Enabled >.
5. Go to Boot\CSM and set ?œCSM??to <Disabled>.
6. Press [F10] to save your changes and exit, and then enter the UEFI Setup again.
7. After saving the previously changed settings via [F10] and rebooting the system, the ?œRAIDXpert2
Configuration Utility??submenu becomes available.
Go to Advanced\RAIDXpert2 Configuration Utility\Array Management, and then delete the existing disk
arrays before creating a new array.
Even if you have not configured any RAID array yet, you might have to use ?œDelete Array??first.
Go to Advanced\RAIDXpert2 Configuration Utility\Array Management\Create Array
9A. Select ?œRAID Level??
9B. Select ?œSelect Physical Disks??
9C. Change ?œSelect Media Type??to ?œSSD??or leave at ?œBOTH??
9D. Select ?œCheck All??or enable specific drives that you want to use in the array. Then select ?œApply
Changes??
Select ?œCreate Array??
10. Press [F10] to save to exit.
I have then installed raidexpert2 on windows. Both windows and raid expert don't recognise the array (I'm guessing because of the drivers)
Any suggestions?
|