I have X79 Extreme11 take to long time to run
Printed From: ASRock.com
Category: Technical Support
Forum Name: Intel Motherboards
Forum Description: Question about ASRock Intel Motherboards
URL: https://forum.asrock.com/forum_posts.asp?TID=2922
Printed Date: 27 Dec 2024 at 5:31am
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: I have X79 Extreme11 take to long time to run
Posted By: alazabe
Subject: I have X79 Extreme11 take to long time to run
Date Posted: 25 Jun 2016 at 3:38am
|
Hi My motherboard debug led is going crazy it go 60 61 39 then d6 i need help icant even go to the the motherboard UEFI only after a long time like 10 to 20 muintes PLS help me to fix it soon Thanks
|
Replies:
Posted By: alazabe
Date Posted: 27 Jun 2016 at 1:29pm
|
Why there no help ? here a video of the motherboard debug light https://www.youtube.com/watch?v=5EoNbD3Pxe0 Pls help asap |
Posted By: vacaloca
Date Posted: 28 Jun 2016 at 5:13am
|
Would be ideal if you post detailed system/component specs... it's hard to debug when no one is aware of what components (RAM, power supply, CPU, etc) you are using on the board.
Without knowing anything else: 0a) Make sure BIOS version on board supports the CPU you have installed. 1) Make sure CPU is seated correctly on slot 2) Make sure RAM is seated correctly -- try using only 1 DIMM and/or using a different memory DIMM 3) Make sure video card is seated correctly -- try changing video cards if possible
|
Posted By: Xaltar
Date Posted: 28 Jun 2016 at 5:23am
|
Clear CMOS using http://forum.asrock.com/forum_posts.asp?TID=630&title=how-to-clear-cmos-via-battery-removal" rel="nofollow - this method then post back your results. Also please provide system specs and answer the following: Age of PC? Is this a new problem? Did the PC work normally before? ------------- 
|
Posted By: parsec
Date Posted: 28 Jun 2016 at 12:09pm
No, the Dr Debug LED display is not going crazy when it shows those numbers, which are called POST codes. It is normal for the codes to be displayed on the display. If the PC completes POST, the codes disappear. If one code stays on the display, and does not change or turn off, that code tells you in general what is wrong. Since there was a problem with some part of your hardware, the PC could not start or boot, and the startup process was stopped. This can happen to any PC. So the last code you get is d6, is that right? If you look at your board's information page, the FAQ section has information about the Dr Debug codes. You can find that here: http://www.asrock.com/mb/Intel/X79%20Extreme11/?cat=FAQ" rel="nofollow - http://www.asrock.com/mb/Intel/X79%20Extreme11/?cat=FAQ We can see that a d6 code is a problem with the video card: The VGA could not be recognized. Please clear CMOS and try re-installing the VGA card. If the problem still exists, please try installing the VGA card in other slots or use other VGA cards. What video card are you using, and which slot is it in? ------------- http://valid.x86.fr/48rujh" rel="nofollow"> 
|
alazabe wrote: