Dead link for F-Stream Tuning Utility ver:3.0.140
Printed From: ASRock.com
Category: Technical Support
Forum Name: AMD Motherboards
Forum Description: Question about ASRock AMD motherboards
URL: https://forum.asrock.com/forum_posts.asp?TID=5601
Printed Date: 10 Jan 2025 at 7:26am Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: Dead link for F-Stream Tuning Utility ver:3.0.140
Posted By: Morbidity
Subject: Dead link for F-Stream Tuning Utility ver:3.0.140
Date Posted: 16 Jul 2017 at 7:35am
" rel="nofollow - I was trying to download this program, but the link appears to be dead?
EDIT: I found, http://www.asrock.cn/support/download.asp?cat=Utilities, which leads to a newer version found on an itx board. I assume these are the same programs, but just a newer version. Though, it makes one wonder why asrock has older versions on their other pages. The one for the gaming X is actually newer than the one for the k4. idk
|
Replies:
Posted By: wardog
Date Posted: 16 Jul 2017 at 9:37am
" rel="nofollow - What MB is it you have?
|
Posted By: Morbidity
Date Posted: 16 Jul 2017 at 10:13am
The x370 Fatality Gaming X.
I am trying to figure out a way to control the fans, because I can't find the option in the bios.
|
Posted By: wardog
Date Posted: 16 Jul 2017 at 10:30am
Morbidity wrote:
The x370 Fatality Gaming X.
I am trying to figure out a way to control the fans, because I can't find the option in the bios.
|
BIOS > H/W Monitor tab/page
|
Posted By: Morbidity
Date Posted: 16 Jul 2017 at 9:49pm
" rel="nofollow -
wardog wrote:
Morbidity wrote:
The x370 Fatality Gaming X.
I am trying to figure out a way to control the fans, because I can't find the option in the bios.
|
BIOS > H/W Monitor tab/page
|
If you don't mind, can you answer another stupid question!?
How do I OC On this board?
I can set the voltage in one place, but then it forces me to use auto or an offset. When it was running at stock, it showed it pulling ridiculous amounts of voltage.
Auto is usually bad, so do I set it to the lowest offset, 65mv, and then just add that to the voltage I set?
Odd...
|
|