Z370 Extreme4 Blackscreen ram don't run at 3200
Printed From: ASRock.com
Category: Technical Support
Forum Name: Intel Motherboards
Forum Description: Question about ASRock Intel Motherboards
URL: https://forum.asrock.com/forum_posts.asp?TID=7018
Printed Date: 02 Aug 2025 at 1:06am
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: Z370 Extreme4 Blackscreen ram don't run at 3200
Posted By: Marceel
Subject: Z370 Extreme4 Blackscreen ram don't run at 3200
Date Posted: 20 Dec 2017 at 9:33pm
" rel="nofollow - [URL=][/URL]There is a problem, I noticed that the RAM runs only with 2100 (approx.) Instead of 3200.
I had it in A1 and B1, now I read that you should put it in A2 + B2 because several have this problem.
From left to right 1234, 1 A1 2 A2 3 B1 4 B2
Then I just made the bars in A2 and B2, connected everything, etc. and the PC is running all the fans are spinning, LEDs and RGBs work but I get no picture ...
Have also tried only 1 Ram bars or in A2. But nothing works. Have also taken out the mainboard battery and put it back in, power cord removed before and the on / off button on the power supply on / off made etc. Start button held down as no power cable was connected, but I just can not get a picture.
Have else changed the SATA connection to 0, but would have synonymous without hard drive image or get into the BIOS.
What's going on there?
|
Replies:
Posted By: hansi12
Date Posted: 21 Dec 2017 at 12:12am
" rel="nofollow - Have you checked if A1 or B1 still works?
Have you done a cmos reset?
|
Posted By: Marceel
Date Posted: 21 Dec 2017 at 2:03am
don't work A1 and B1...
I have removed the battery from the board.
|
Posted By: Marceel
Date Posted: 21 Dec 2017 at 11:30pm
|
" rel="nofollow - with Jumper too... What now? help pls
|
Posted By: hansi12
Date Posted: 22 Dec 2017 at 4:40am
" rel="nofollow - So it ran before and now it doesnt with the same configuration? It looks like its defective right?
Try a minimal setup, or other hardware to rule out the defective parts.
|
|