Double SSD heat sink - protective film removal
Printed From: ASRock.com
Category: Technical Support
Forum Name: AMD Motherboards
Forum Description: Question about ASRock AMD motherboards
URL: https://forum.asrock.com/forum_posts.asp?TID=75068
Printed Date: 03 Jan 2025 at 1:10am
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: Double SSD heat sink - protective film removal
Posted By: PapaFrito
Subject: Double SSD heat sink - protective film removal
Date Posted: 31 Oct 2024 at 2:43am
|
Hi, I've got B650 Steel Legend Wifi board: https://www.asrock.com/MB/AMD/B650%20Steel%20Legend%20WiFi/index.asp#Overview" rel="nofollow - https://www.asrock.com/MB/AMD/B650%20Steel%20Legend%20WiFi/index.asp#Overview I'm currently assembling the rig. I bought a single SSD NVMe and I want to install it in one of the two Gen 4 slots, which are covered by a single heat shield. It comes with 2 thermal pads, one for each SSDs. Both are covered with a plastic strip (protective film) which has to be removed. The question is - Am I supposed to remove both protective films if I'm currently going to install and use only one SSD? The information is nowhere to be found except that the manual describes each slot installation separately but says "protective films" in plural. |
Replies:
Posted By: PapaFrito
Date Posted: 01 Nov 2024 at 3:34am
| Ended up leaving the protective film on the other pad... |
Posted By: NDRE28
Date Posted: 01 Nov 2024 at 11:19am
Hello! That's the correct decision. |
PapaFrito wrote: