Error code d3 890FX deluxe 4
Printed From: ASRock.com
Category: Technical Support
Forum Name: AMD Motherboards
Forum Description: Question about ASRock AMD motherboards
URL: https://forum.asrock.com/forum_posts.asp?TID=8723
Printed Date: 19 Jul 2025 at 7:34am
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: Error code d3 890FX deluxe 4
Posted By: lamensje
Subject: Error code d3 890FX deluxe 4
Date Posted: 19 May 2018 at 2:51am
|
" rel="nofollow - I get error code d3 when trying to boot the system. I verified when I bought the motherboard it was working. I verified the psu is working properly (It's a brand new one). I verified the ram is working. I verified the cpu is working in another motherboard.
I already tried the following: - reset bios - 1 stick of ram - different ram - different ram slot - reseating the cpu What did I miss? |
Replies:
Posted By: lamensje
Date Posted: 19 May 2018 at 2:54am
| I forgot to tell the system has booted successfully before (same hardware config), just the day after it gave this error. |
Posted By: kerberos_20
Date Posted: 19 May 2018 at 2:57am
|
" rel="nofollow - d3 - Some of the Architectural Protocols are not available cpu is not compatible? ------------- http://valid.x86.fr/diq4l4" rel="nofollow">  http://www.userbenchmark.com/UserRun/47132492" rel="nofollow - userbenchmark |
Posted By: lamensje
Date Posted: 19 May 2018 at 3:09am
| The system already worked before with the cpu, it just started to give these error the next day. |
Posted By: lamensje
Date Posted: 19 May 2018 at 3:10am
|
Error D0 means: If memory sizing module not executed, start memory refresh and domemory sizing in Bootblock code. Do additional chipset initialization.Re-enable CACHE. Verify that flat mode is enabled But I don't have a clue what to do with that.
|
Posted By: kerberos_20
Date Posted: 19 May 2018 at 3:13am
|
" rel="nofollow - nope, u have aptio 4.x bios u are looking into different status codes d0 - CPU initialization error what is your CPU and bios version? ------------- http://valid.x86.fr/diq4l4" rel="nofollow"> http://www.userbenchmark.com/UserRun/47132492" rel="nofollow - userbenchmark |
Posted By: lamensje
Date Posted: 19 May 2018 at 3:49am
|
" rel="nofollow - I have a Phenom II x6 1090T. The pc is from a friend of mine and I just left, I will ask him tomorrow what bios version the mobo has (sticker on the bios chip right?).
|
Posted By: lamensje
Date Posted: 19 May 2018 at 5:16pm
| I have bios version 1.10-15B |
Posted By: lamensje
Date Posted: 19 May 2018 at 5:59pm
|
I tried my own working ram and the system somehow booted up successfully, I don't understand why the other verified working (non ecc) ram also didn't work. Anyway, thanks for the help. It turned out the ram my friend had was ECC registered ram, which obviously doesn't work.
|