4.7 UEFI BIOS well worth upgrade X370 Taichi
Printed From: ASRock.com
Category: Technical Support
Forum Name: AMD Motherboards
Forum Description: Question about ASRock AMD motherboards
URL: https://forum.asrock.com/forum_posts.asp?TID=9030
Printed Date: 01 Nov 2025 at 6:01am
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: 4.7 UEFI BIOS well worth upgrade X370 Taichi
Posted By: cx5
Subject: 4.7 UEFI BIOS well worth upgrade X370 Taichi
Date Posted: 27 Jun 2018 at 10:23am
|
Hi guys, Just quick share something that I didn't know before, may be you guys do (hence please pardon if repeated). It shows all the ohms/resistance/impedance. No more guessing for these values. As well as helps me runs at 1T, instead of previously left at 2T. GearDown Enabled too.  ------------- x370taichi@3.50gen4 AX750 Optane900P SN770 3800x PosdonZro4 BarrowPWM-17w>420x140x28 XFX SWFT319 6900XT MSI RX560 LP to get Fluid Motion BlueskyFRC 75hz |
Replies:
Posted By: datonyb
Date Posted: 27 Jun 2018 at 7:42pm
|
" rel="nofollow - apperently with geardown enabled your actually running at 1.5t but im a little confused are you saying with bios earlier than 4.7 the timing checker dosnt display the ohms etc ? ------------- [url=https://valid.x86.fr/jpg250]  [/url]3800X, powercolor reddevil vega64, gskill tridentz3866, taichix370, evga750watt gold |
Posted By: cx5
Date Posted: 27 Jun 2018 at 8:12pm
hi da tony b, long time no see. YES, your assumption is correct, when I was on bios 3.2 the ohms are all N/A. ------------- x370taichi@3.50gen4 AX750 Optane900P SN770 3800x PosdonZro4 BarrowPWM-17w>420x140x28 XFX SWFT319 6900XT MSI RX560 LP to get Fluid Motion BlueskyFRC 75hz |
datonyb wrote:Posted By: cx5
Date Posted: 08 Jul 2018 at 9:00pm
|
good news When I was on older bios uefi 3.2 the SoC voltage would show red at 1.2v hence I never used higher than 1.2v. plus, SoC voltage 1.312v is the LAST_KEY, plus dram voltage 1.44v plus VTT 0.72v, immediately boots windows gaming ok. http://valid.x86.fr/76sqea" rel="nofollow - http://valid.x86.fr/76sqea  Then try lowest timing record from previous success also OK.  ------------- x370taichi@3.50gen4 AX750 Optane900P SN770 3800x PosdonZro4 BarrowPWM-17w>420x140x28 XFX SWFT319 6900XT MSI RX560 LP to get Fluid Motion BlueskyFRC 75hz |
Posted By: datonyb
Date Posted: 08 Jul 2018 at 9:34pm
|
mate over 1.2v soc is not advised this was from amd on ryzen launch i believe mine runs better on LOWER soc eg 1.05 is better than 1.2 or 1.1 it is at the end of the day your equipment but i feel its best to advise you this may well be damaging your cpu/board ------------- [url=https://valid.x86.fr/jpg250] [/url]3800X, powercolor reddevil vega64, gskill tridentz3866, taichix370, evga750watt gold |
Posted By: cx5
Date Posted: 08 Jul 2018 at 9:41pm
|
Hi da tony b, Thanks for good warning and reminder...... shxt..... what have I gotten myself into now......... but I'm going to gamble on it for a while !!! report back when it's dead   in advance to break the jinx !!!!! I need all the luck now !!!!!!------------- x370taichi@3.50gen4 AX750 Optane900P SN770 3800x PosdonZro4 BarrowPWM-17w>420x140x28 XFX SWFT319 6900XT MSI RX560 LP to get Fluid Motion BlueskyFRC 75hz |