B450M-HDV R4.0 no display enabling Rebar

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   It would seem you have already followed all the troubleshooting steps I would 
recommend. That said, I will list them again here:

1. Clear CMOS
2. Disable CSM then save and exit the UEFI
3. Check to ensure CSM is disabled
4. Enable "above 4g decoding" and "Rebar/SAM"
5. Save and exit

If that does not work then I would open a support ticket with ASRock and inquire
with them directly:
https://tw.asrock.com/events/tsd.asp?kind=MB

Good luck 

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Xaltar Members Profile Send Private Message Find Members Posts Add to Buddy List Moderator Group Joined: 16 May 2015 Location: Europe Status: Offline Points: 39253	Post Options Post Reply Quote Xaltar Report Post Thanks(0) Quote Reply Topic: B450M-HDV R4.0 no display enabling Rebar Posted: 2 hours 34 minutes ago at 7:06pm
	It would seem you have already followed all the troubleshooting steps I would recommend. That said, I will list them again here: 1. Clear CMOS 2. Disable CSM then save and exit the UEFI 3. Check to ensure CSM is disabled 4. Enable "above 4g decoding" and "Rebar/SAM" 5. Save and exit If that does not work then I would open a support ticket with ASRock and inquire with them directly: https://tw.asrock.com/events/tsd.asp?kind=MB Good luck


al3ks_a Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 2 hours 54 minutes ago Location: Serbia Status: Offline Points: 15	Post Options Post Reply Quote al3ks_a Report Post Thanks(0) Quote Reply Posted: 2 hours 42 minutes ago at 6:58pm
	Technical support request: "No Signal" issue when enabling SAM (ReBAR) - ASRock B450M-HDV R4.0 & RX 6650 XT & Ryzen 7 5700x I am contacting you regarding an issue where my system fails to output a display signal when enabling SAM (ReBAR and Above 4G Decoding). I have verified that my hardware configuration supports these features, but I am encountering a boot failure after POST despite correct settings. OS: Win 11 (Installed in UEFI/GPT mode) Driver: Adrenalin 26.6.1 (latest) Troubleshooting steps performed: Updated BIOS to latest version (11.0) Verified that Windows is on a GPT partition Disabled CSM Set "PCIe x16 Speed" to Gen3 in the AMD PBS menu manually Disabled "Fast Boot" Set "Secure Boot" to Standard mode Confirmed that I am using the latest VBIOS I could find, and driver version as I stated earlier, also updated firmware to latest. Cleared CMOS Photos: https://imgur.com/a/TlvfVbX https://imgur.com/a/4aaMB2p (here you can see it doesn't say "Not Available" but "Disabled"