|
Asrock b450 pro4 + Ryzen 5 3600, Problem! help!!! |
Post Reply 
|
| Author | |
kschendel 
Newbie 
Joined: 21 Aug 2018 Status: Offline Points: 86 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Asrock b450 pro4 + Ryzen 5 3600, Problem! help!!!Posted: 26 Oct 2019 at 12:49am |
|
No, the only way to update the BIOS is to have a processor that works with the existing BIOS rev. Ideal would be a 1st gen Ryzen. AMD do have an upgrade loaner program that you might look into. Other options are find someone to borrow a CPU from, or worst case buy a 1200 CPU, do the upgrade, then sell it.
|
|
 |
|
|
GO2019
Newbie
Joined: 22 Oct 2019 Location: sc Status: Offline Points: 10 |
Post Options
Thanks(0)
Quote Reply
Posted: 22 Oct 2019 at 11:06pm |
|
Hi guys, thank you very much for your kind help. I have shorted CMOS for 7 hours. And then put memory in A2 slot (single memory). I tried this morning. It still does not work. Now the only thing I have not tried is the bios update. But how can i update the bios without getting the booting page? I have checked, this MB does not have flash bios button (physically). Is there any other way to do it? Thanks a lot!
|
|
|
|
|
Xaltar
Moderator Group 
Joined: 16 May 2015 Location: Europe Status: Offline Points: 25073 |
Post Options
Thanks(0)
Quote Reply
Posted: 22 Oct 2019 at 9:46pm |
|
Make sure your GPU is properly seated. It is easy for it to pop up out of the
slot when bench testing if the board isn't elevated or on the edge of the table etc. The PCI bracket extends lower than the board sits. Only connect the GPU, power, CPU and one stick of RAM. Make sure all connections are secure and you have an 8pin (4+4) power connector hooked up not a PCIe (6+2). |
|
|
|
|
|
|
Ray62
Groupie 
Joined: 01 Jul 2018 Location: Germany, Berlin Status: Offline Points: 706 |
Post Options
Thanks(0)
Quote Reply
Posted: 22 Oct 2019 at 2:52pm |
And sad that there is not much too see. - I cannot really see a video cable at the graphics card - I cannot see a keyboard connected - But i can see: RAM is placed in A1/B1 instead of A2/B2 You should try it with one stick in A2 first. And than make a CMOS Reset and restart. And wait, wait, wait, longer as you think you have to wait. If nothing changes after several minutes (say max. 15 min), it is probably what gizmic already posted: Bios too old for the Ryzen 5 3600 |
|
|
Asrock Fatal1ty X370 Professional Gaming Offline
Under test: MSI X570_MEG_ACE | AMD Ryzen 9 3900X | Scythe Mugen5 | 2x16GB F4-3200C14D-32GTZ@3466 | ASUS GeForce GTX 1080 Ti FE |
|
|
|
|
gizmic
Groupie
Joined: 13 Jun 2018 Location: Hong Kong Status: Offline Points: 677 |
Post Options
Thanks(0)
Quote Reply
Posted: 22 Oct 2019 at 12:31pm |
|
put rams on a2 and b2
only 2 things i can think of 1 its doing ram training 2 bios is not updated |
|
|
|
|
|
|
GO2019
Newbie
Joined: 22 Oct 2019 Location: sc Status: Offline Points: 10 |
Post Options
Thanks(0)
Quote Reply
Posted: 22 Oct 2019 at 11:21am |
|
update, I realized that there is no GPU with CPU. So I installed a dedicated low profile video card. Here is the video https://www.youtube.com/watch?v=Ljski7h7Fqs.
However, it still shows the same rebooting thing and there is no display on the monitor. Sad! |
|
|
|
|
GO2019
Newbie
Joined: 22 Oct 2019 Location: sc Status: Offline Points: 10 |
Post Options
Thanks(0)
Quote Reply
Posted: 22 Oct 2019 at 8:43am |
|
Please see the video I posed on the youtube : https://www.youtube.com/watch?v=ymQ2ONKB_N4
The symptom is: CPU and power supply keep rebooting but there is nothing displaying on the monitor after I jump the "power on" two pings. We have tested the memory with another system, they are fine. We have tried three power supplies. Same thing. We have returned and replaced both CPU and motherboard. Still the same. What can be wrong? Please advise. Thanks a lot! Btw, the CPU fan is just a temp solution.It is small but has four pin connector and was a CPU fan for some old system. Right now we are using on-board HDMI for display but I have tried the dedicated video card, no difference. Also there is no hard drive connected but that does not matter, since at least we should see the booting page and bios. Did we miss something stupid??? This happened to anyone here? Please help! Thanks a lot! |
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options
GO2019 wrote: