![]() |
Bios error? |
Post Reply ![]() |
Page 12> |
Author | |
Hartukktu ![]() Newbie ![]() Joined: 16 Jan 2018 Location: Leiden Status: Offline Points: 10 |
![]() ![]() ![]() ![]() ![]() Posted: 26 Feb 2020 at 5:44pm |
As in physically disconnecting the powercable, and wait until all the merry leds on the motherboard have darkened. And then apply the jumper and wait some minutes.
|
|
![]() |
|
Hartukktu ![]() Newbie ![]() Joined: 16 Jan 2018 Location: Leiden Status: Offline Points: 10 |
![]() ![]() ![]() ![]() ![]() |
Do not forget that to REALLY clear the CMOS, you als need to disconnect from the wall power.
|
|
![]() |
|
Chicken69 ![]() Newbie ![]() Joined: 09 Feb 2020 Location: Viet nam Status: Offline Points: 7 |
![]() ![]() ![]() ![]() ![]() |
I used instant flash. RGB Led still on, cpu still heating up when I turn it on.
|
|
![]() |
|
RLGL ![]() Senior Member ![]() ![]() Joined: 29 Jul 2018 Location: MN Status: Offline Points: 2025 |
![]() ![]() ![]() ![]() ![]() |
Did you flash through windows or use instant flash? If a windows flash the board is probably bricked
|
|
Asrock Z370 Gaming K6,Intel i7 8700K,
Asrock x570 Taichi |
|
![]() |
|
Chicken69 ![]() Newbie ![]() Joined: 09 Feb 2020 Location: Viet nam Status: Offline Points: 7 |
![]() ![]() ![]() ![]() ![]() |
I tried too, same result, 3 short beeps then followed by another 3 short beeps
|
|
![]() |
|
Reset ![]() Newbie ![]() Joined: 13 Jan 2020 Status: Offline Points: 99 |
![]() ![]() ![]() ![]() ![]() |
Just do a RAM in A2 and then test it.
|
|
![]() |
|
Chicken69 ![]() Newbie ![]() Joined: 09 Feb 2020 Location: Viet nam Status: Offline Points: 7 |
![]() ![]() ![]() ![]() ![]() |
Clear cmos not helping :(
|
|
![]() |
|
Reset ![]() Newbie ![]() Joined: 13 Jan 2020 Status: Offline Points: 99 |
![]() ![]() ![]() ![]() ![]() |
If you set the clear jumper from the CMOS, you don't have to wait hours. A few minutes will do.
|
|
![]() |
|
Chicken69 ![]() Newbie ![]() Joined: 09 Feb 2020 Location: Viet nam Status: Offline Points: 7 |
![]() ![]() ![]() ![]() ![]() |
I waited for hours but nothing happened. Now I?™m trying to remove the cmos battery and wait for couper of hours.
|
|
![]() |
|
Reset ![]() Newbie ![]() Joined: 13 Jan 2020 Status: Offline Points: 99 |
![]() ![]() ![]() ![]() ![]() |
Reset the jumper to CMOS.
If this does not help, try it with a RAM latch only. The first start after a BIOS update may take a moment. |
|
![]() |
Post Reply ![]() |
Page 12> |
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |