B450 K4 Gaming red LED blinks, doesn't start.

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Solved. Answer from support:
-------------
B450 chipset mainly supports Summit/Raven/Pinnacle/Picasso/Matisse CPU.

Since 9700 is a Bristol Ridge CPU, thus, it is not supported.

Kindly refer to the link below for the supported CPU.
https://www.asrock.com/MB/AMD/Fatal1ty%20B450%20Gaming%20K4/index.asp#CPU
--------------

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
P_M Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 15 Feb 2020 Status: Offline Points: 5	Post Options Post Reply Quote P_M Report Post Thanks(0) Quote Reply Topic: B450 K4 Gaming red LED blinks, doesn't start. Posted: 23 Feb 2020 at 9:52am
	Solved. Answer from support: ------------- B450 chipset mainly supports Summit/Raven/Pinnacle/Picasso/Matisse CPU. Since 9700 is a Bristol Ridge CPU, thus, it is not supported. Kindly refer to the link below for the supported CPU. https://www.asrock.com/MB/AMD/Fatal1ty%20B450%20Gaming%20K4/index.asp#CPU --------------

P_M Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 15 Feb 2020 Status: Offline Points: 5	Post Options Post Reply Quote P_M Report Post Thanks(0) Quote Reply Posted: 15 Feb 2020 at 5:25pm
	ADD: Bios version is unknown, I think something from end-2019.

P_M Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 15 Feb 2020 Status: Offline Points: 5	Post Options Post Reply Quote P_M Report Post Thanks(0) Quote Reply Posted: 15 Feb 2020 at 4:19pm
	Hello! I have B450 K4 Gaming Fatality rev 1.01 AMD A10-9700 Bristol Ridge (with video) 2xPatriot PV416G300C6K 3000 MHz (there was no Bristol ridge recomendations in but for Raven, Summit and Pinnacle Ridge there were PVR416G320C6K and PV48G340C6K with more MHz rate) HDMI display Power Supply Chieftec 750W When I connect bother power connectors from PS to MB, red LED under chipset (?) heatsink with Fatality written on it begins blink slowly. When I start MB, cooler starts but no picture on display and after about 20-30s system reboots. I tried connect with another PS 700W from other desktop, but because it was difficult to disconnect all power cables from it I connect B450 only with wide power connect. Red LED begins blink slowly. I found topic about similar situation on X370 Killer SLI/ac http://forum.asrock.com/forum_posts.asp?TID=12386 It suggest to clear CMOS. I disconnect PS plug and there was no jumpers on my MB so I shortened it with staple for 10 sec, but nothing changed. I also tried to start with only 1 RAM module installed in A1 or A2 slot. I don't have other memory to try. Is it possible to find out what problem there ?