B460M Steel Legend - No video when using CSM

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   So I have managed to get video to display when CSM is enabled.

I set all of the CSM options to disabled while keeping CSM itself enabled. Not sure how helpful it was but I also set the boot image to Disabled at the same time so it now displays POST messages. I notice I can only get video to display via the GPU even though the primary GPU is set to Onboard and the iGPU Multi is set to Enabled. I only need CSM enabled temporarily so it isn't a huge issue.

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
joshkrz Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 09 Aug 2020 Status: Offline Points: 4	Post Options Post Reply Quote joshkrz Report Post Thanks(0) Quote Reply Topic: B460M Steel Legend - No video when using CSM Posted: 10 Aug 2020 at 4:51pm
	So I have managed to get video to display when CSM is enabled. I set all of the CSM options to disabled while keeping CSM itself enabled. Not sure how helpful it was but I also set the boot image to Disabled at the same time so it now displays POST messages. I notice I can only get video to display via the GPU even though the primary GPU is set to Onboard and the iGPU Multi is set to Enabled. I only need CSM enabled temporarily so it isn't a huge issue.

joshkrz Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 09 Aug 2020 Status: Offline Points: 4	Post Options Post Reply Quote joshkrz Report Post Thanks(0) Quote Reply Posted: 10 Aug 2020 at 12:22am
	I'm building an Unraid server that requires CSM to be enabled to boot into its GUI mode. When enabling CSM however I get no video output at all from both the Intel i5 10500 integrated graphics or from my Nvidia 1050TI. I have to clear the CMOS to restore video. I have tried the onboard HDMI and the GPU HDMI and DVI. I also upgraded the motherboard firmware to 1.40. If anyone can shed some light on the reason this happens and how I can solve it, that would be great! Thanks!