|
B85m |
Post Reply 
|
| Author | |
parsec 
Moderator Group 
Joined: 04 May 2015 Location: USA Status: Offline Points: 4996 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: B85mPosted: 16 Jun 2015 at 1:49pm |
A list of the other hardware you are using may help figure out the problem. Such as, what CPU, memory, and power supply you are using. Also what video source are you using, a video card or the onboard Intel graphics? Do you have the 4 or 8 pin CPU power cable connected to the board, as well as the 24 pin power cable? You must have both power cables connected. Is your monitor set up to auto detect a signal from any of its inputs? If the monitor is new or you used a different cable with it on another PC, you may need to manually select the input. |
|
 |
|
|
Xaltar
Moderator Group
Joined: 16 May 2015 Location: Europe Status: Offline Points: 24653 |
Post Options
Thanks(0)
Quote Reply
Posted: 16 Jun 2015 at 5:03am |
|
Some simple steps to help find the problem: 2. Check to make sure your RAM is fitted correctly, if it is not firmly seated you will have problems. 3. Make sure the CPU is seated properly in its socket and that there are no bent pins in the socket. My B85 Anniversary powers up in an odd way (at least compared to what I am used to) it does what you described, powers on for a short moment, then off then back on again. This only happens when I have made BIOS changes and also the first time I powered my system. I have had no issues with my system so I assume this is normal. Not getting any display or post however means something isn't connected properly or is damaged. Do you have a system (PC) speaker connected to the motherboard? All motherboards have a system of beeps that help fault finding. A single beep means the system has successfully posted, if this is the case and there is no display you need to check your graphics card and monitor connections. 3 short beeps that repeat is usually memory, if this is the case, remove all the memory and insert a single stick of RAM in slot 2 and attempt to boot again. If the system boots then reinsert the other RAM (if 2 sticks they should be in slots 2 and 4 for best compatibility). If there is still the error code then the RAM is either damaged or not compatible with your motherboard. In my experience the most common cause of a failed post in a new build is RAM or CPU not being seated correctly. After that, power cables not firmly connected. I hope this is of some help.
|
|
|
|
|
Ward.mr
Newbie 
Joined: 16 Jun 2015 Location: Uk Status: Offline Points: 3 |
Post Options
Thanks(0)
Quote Reply
Posted: 16 Jun 2015 at 3:36am |
|
Hi every body just put my self together a b85m model but I have a problem.??
I put it all together following the installation guide but when I go to power the pc up I get a 1/2 second power up then it dies but powers back up. (Sorry for the spelling ) when it dose power back up I have no keyboard mouse or no signal on my Screen .Have I done any think wrong or do I need to do any think. All help is appreciated Thank you. |
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options
Ward.mr wrote: