PC wont power on after BIOS update

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Thanks for the recommendations Xaltar.  I've tried moving the ram onto a different slot. Still no luck.  :( 
Guess I'll see what Asrock support has to say.

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
j40987 Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 23 Jun 2015 Location: Philippines Status: Offline Points: 4	Post Options Post Reply Quote j40987 Report Post Thanks(0) Quote Reply Topic: PC wont power on after BIOS update Posted: 26 Jun 2015 at 5:02pm
	Thanks for the recommendations Xaltar. I've tried moving the ram onto a different slot. Still no luck. :( Guess I'll see what Asrock support has to say.

Xaltar Members Profile Send Private Message Find Members Posts Add to Buddy List Moderator Group Joined: 16 May 2015 Location: Europe Status: Offline Points: 24638	Post Options Post Reply Quote Xaltar Report Post Thanks(0) Quote Reply Posted: 26 Jun 2015 at 4:39pm
	Welcome to the forums So the only change between the working and non working state is the bios update? You have already cleared CMOS by both jumper and battery removal so recommending that again is pointless. The only other thing I can think of trying till Asrock tech support gets back to you is disconnecting and reinstalling everything and try the RAM in the other slot. If that fails I am afraid there is not much I can do to help you.

j40987 Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 23 Jun 2015 Location: Philippines Status: Offline Points: 4	Post Options Post Reply Quote j40987 Report Post Thanks(0) Quote Reply Posted: 26 Jun 2015 at 4:31pm
	Hello everyone, hope you could help me with my issue. First off the specifics. ASROCK Z68m-tix/ht - serial 1AM0X2045450 Intel i3 2100 sandy bridge CPU 4GB Kingston DDR3 1333 RAM KVR13N9S8/4 Working BIOS - P 1.20 I was able to install windows xp 32bit just fine and everything was working. PC posts and all was okay. However when I installed NVIDIA drivers for GT 720 and placed the GPU in the GPU PCIe socket there would be no display. I removed the card and tried booting and the display works. I checked the bios and made sure to set priority to the discrete graphics card but it still did not display. At this point the PC was still working. It just would not display despite fans running when the GPU was installed. I looked at possible bios update and downloaded latest BIOS from ASROCK website, 2.40. I booted into UEFI and did a bios update through there. Everything seemingly went fine. The progress bar filled and a notification came out indicating update was successful. Then everything went blank. I thought this was normal and waited. I had the PC on bread board and noted that the CPU fan was turning on and off and there was no signal to the display. After a long while it was still doing this so I had to power it down. Until now there is no display. I tried to clear CMOS with jumper and taking out the battery as well and leaving it to discharge. I tried making an DOS bootable USB with the ROM file of BIOS version 2.20 from the download page (not sure if I did it right, used RUFUS then put the ROM in the root of USB), but still none of these seems to help and the pc will not post and the CPU fan just turns on and off. I've sent ASROCK support mail, but there's still no reply. Any idea what I can do to get this running again?