SOLVED ASRock FATAL1TY Z170 GAMING K4 not booting

http://www.corsair.com/en-us/memory-finder

https://www.kingston.com/us/memory/search/Options

https://patriotmemory.com/memory-finder/


Those are the ones I'll use, in order, beginning with G.Skill.

Concerning that F4-3000C15D-16GVKB kit you have, and sorry if this thought comes seemingly late in the game/Thread here. Diagnosing over the internet ain't easy. By any means.

Too many posts to go back over, ............

After clearing the BIOS as you have been, does it boot at their default JEDEC timings and speed of 2133?

I sent you a PM.




Edited by wardog - 10 Dec 2016 at 7:38am

couldbebetter wrote: I've new barebone setup right now and I'm trying to debug my system. The motherboard has Intel Core i5-6600K and G.SKILL Ripjaws V Series 16GB (2 x 8GB) 288-Pin SDRAM DDR4 3000 (PC4 24000) Intel Z170 Memory Kit F4-3000C15D-16GVKB (supported) and it just starts but nothing shows on the screen. Processor fan runs nicely but as I don't have speaker in my system, I'm not keeping any beeps anywhere. Prior this I had Samsung M.2 SSD connected to the system and then it booted up for 5 second (based on fan), stopped and booted up again and never showed anything on display. Currently, I've connected the display through HDMI into my PC monitor through MB connector but the aim is to hook up my GTX1080 once things start working. Any ideas what I should try?

Sorry, but I don't seen the G.SKILL F4-3000C15D-16GVKB kit in your board's memory support list:

http://www.asrock.com/mb/Intel/Fatal1ty%20Z170%20Gaming%20K4/?cat=Memory

Unless you have the wrong part number, which I have a feeling you do. Searching on GVKB and GVK models, both result in 3200 speed kits, not 3000 speed.

If you have 8GB DIMMs, they should be used in the A1 and B1 slots.

Your PC began the POST process, but cannot boot an OS until one is installed. So if it started for about five seconds the first time you ever turned it on, it barely started the POST process, and failed POST very early on. That is usually a memory or CPU problem.

See this page for memory recommended by G.SKILL for your system:

http://www.gskill.com/en/configurator?manu=52&chip=2484&model=2518

But, that list is incomplete, since I use G.SKILL 3200 TridentZ memory in my Z170 Extreme7+ board, which G.SKILL does not include in their list for my board. Both your and my board's list ends at 2800 speed memory.

I managed to find DVI cable (I'm such a computer stuff horder that I might even find VGA cable ;-)) even though I thought that I had thrown all of them away when moving to DP/HDMI era.

couldbebetter wrote: I checked CPU power as I had seen that somebody in this forum had done that mistake. I reset BIOS as advised in this forum.