ASRock.com Homepage
Forum Home Forum Home > Technical Support > Intel Motherboards
  New Posts New Posts RSS Feed - My PCIe2 slot has "gone bad" and doesn't work
  FAQ FAQ  Forum Search Search  Events   Register Register  Login Login

My PCIe2 slot has "gone bad" and doesn't work

 Post Reply Post Reply
Author
Message Reverse Sort Order
parsec View Drop Down
Moderator Group
Moderator Group
Avatar

Joined: 04 May 2015
Location: USA
Status: Offline
Points: 4996
Post Options Post Options   Thanks (0) Thanks(0)   Quote parsec Quote  Post ReplyReply Direct Link To This Post Topic: My PCIe2 slot has "gone bad" and doesn't work
    Posted: 15 Feb 2017 at 12:43am
Originally posted by KimaRo KimaRo wrote:

Hello, I've had my Z77 Extreme4 motherboard for a couple of years now (not really sure how long to be honest) and it recently didn't turn the monitor on when I started up my PC, so I changed the PCIe2 slot to the PCIe3 (which is only 8x). This has made gaming horrible, Witcher 3 is sometimes unplayable if I go into battle, it drops to the mid 20's in FPS. If I use Igni (a fire spell, for those that doesn't know) it also goes down to the 20's. This is super annoying and frustrating, 

I've been watching my GPU usage while testing some games and it doesn't go at 100%. Usually it's around 60~%

Here's an image on how it usually is. http://puu.sh/u2L1O/ea30735cbc.png

The issue I've started running into is that whenever I use Steam Link, it drops my FPS insanely. Life is Strange doesn't go over 30fps. CS:GO is around 24FPS. Is there anything I can do? I've tried everything, I've disabled my iGPU.

Also, when I check on my BIOS on what Gen i can use I have either Auto or Gen1. It should give me Gen3 aswell which is what it should be at (I just hope that Auto gives Gen3)

Anyway, here's my specs: 

i5 3570k @ 4Ghz (4.2 boost)
970 @ 1400Mhz Gainward Phantom
16GB @ 1866Mhz Corsair Platinum Dominator
And all of my games are installed on my 2TB Seagate Barracuda.

Some are installed into either my Samsung 840 SSD or my Intel 330 SSD


The drop in gaming performance you apparently have does not make sense. Since you have an Ivy Bridge i5-3570K CPU, you have PCIe 3.0 support for both of the PCIe x16 slots.

It is well known that the difference in performance between a PCIe 3.0 x8 and PCIe 3.0 x16 connection for a video card that is not driving a 4K monitor, will be very small, or no difference whatsoever. The worst case performance difference would be less than 5%, and that would be very unusual.

When you moved the video card to the other PCIe x16 slot, did you clear the BIOS/CMOS before you started the PC again? If you didn't, you really must do that any time you do a major change in the way hardware is connected to a mother board.

What BIOS version do you have in the board now?
Back to Top
Xaltar View Drop Down
Moderator Group
Moderator Group
Avatar

Joined: 16 May 2015
Location: Europe
Status: Offline
Points: 27173
Post Options Post Options   Thanks (0) Thanks(0)   Quote Xaltar Quote  Post ReplyReply Direct Link To This Post Posted: 14 Feb 2017 at 10:43pm
Download and install GPUz. When you open it you will see a little "?" next to the PCIe Link speed readout. Clicking that will pop up a render test, run it and see what the link speed readout says with the GPU loaded.

It should go up to the maximum supported Gen of your CPU/motherboard (gen 3). If not then pull the GPU, clean the slot out carefully with either a can of compressed air or a compressor and clean the contacts on the GPU itself carefully. Reseat it and test again. 
Back to Top
KimaRo View Drop Down
Newbie
Newbie
Avatar

Joined: 14 Feb 2017
Location: Sweden
Status: Offline
Points: 3
Post Options Post Options   Thanks (0) Thanks(0)   Quote KimaRo Quote  Post ReplyReply Direct Link To This Post Posted: 14 Feb 2017 at 8:55pm
Hello, I've had my Z77 Extreme4 motherboard for a couple of years now (not really sure how long to be honest) and it recently didn't turn the monitor on when I started up my PC, so I changed the PCIe2 slot to the PCIe3 (which is only 8x). This has made gaming horrible, Witcher 3 is sometimes unplayable if I go into battle, it drops to the mid 20's in FPS. If I use Igni (a fire spell, for those that doesn't know) it also goes down to the 20's. This is super annoying and frustrating, 

I've been watching my GPU usage while testing some games and it doesn't go at 100%. Usually it's around 60~%

Here's an image on how it usually is. http://puu.sh/u2L1O/ea30735cbc.png

The issue I've started running into is that whenever I use Steam Link, it drops my FPS insanely. Life is Strange doesn't go over 30fps. CS:GO is around 24FPS. Is there anything I can do? I've tried everything, I've disabled my iGPU.

Also, when I check on my BIOS on what Gen i can use I have either Auto or Gen1. It should give me Gen3 aswell which is what it should be at (I just hope that Auto gives Gen3)

Anyway, here's my specs: 

i5 3570k @ 4Ghz (4.2 boost)
970 @ 1400Mhz Gainward Phantom
16GB @ 1866Mhz Corsair Platinum Dominator
And all of my games are installed on my 2TB Seagate Barracuda.

Some are installed into either my Samsung 840 SSD or my Intel 330 SSD
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.04
Copyright ©2001-2021 Web Wiz Ltd.

This page was generated in 0.140 seconds.