New build Asrock B760M-H/M.2, won£™t boot |
Post Reply |
Author | |
Kws77
Newbie Joined: 30 Jun 2024 Location: Argentina Status: Offline Points: 35 |
Post Options
Thanks(0)
Posted: 25 Aug 2024 at 10:16pm |
I forgot to update. It was a M2 wifi card that was not compatible what caused the issue. I took it out and it boot. Later I bought one from the few models that are recommended and it worked fine too.
|
|
Xaltar
Moderator Group Joined: 16 May 2015 Location: Europe Status: Offline Points: 25073 |
Post Options
Thanks(0)
|
Check your motherboard for a BIOS version. It should be printed on a plain white
sticker on the BIOS ROM chip. It needs to be BIOS version 2.02 or higher to support 14th gen. If it is 2.02 or higher then try the following: Follow this guide: https://forum.asrock.com/forum_posts.asp?TID=630&title=how-to-clear-cmos-via-battery-removal In addition, install/connect only the 24pin power, 8pin CPU power and a single stick of RAM in slot A2 and the CPU. Connect your display only, no USB devices, no SSDs/drives or other cables. I have seen USB devices cause issues like this, the same goes for M.2 drives. If the system gives you a proper POST screen in the configuration above, reinstall your other devices one at a time, testing before installing the next. That should tell you what is causing the issue. I would start with adding your second RAM module in slot B2 then move on from there. Edited by Xaltar - 01 Jul 2024 at 12:15am |
|
|
|
Kws77
Newbie Joined: 30 Jun 2024 Location: Argentina Status: Offline Points: 35 |
Post Options
Thanks(0)
|
Hi! I have a new pc but won't boot up. It's a Asrock B760M-H/M.2, intel i7 14700 (gpu integrated), ddr5 32gb (6400mhz). It turns on, everything lights up, there's no beep, and the screen shows only a low dash without blinking. I tried pressing F2 or Del, but nothing works. I tried taking out the battery, clear CMOS jumper, reinstalling ram and ssd. Didn't try updating bios though. The motherboard's case says is ready for intel 14th gen cpu, so the bios should support it. Any ideas?
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |