Breadboarding |
Post Reply |
Author | |
parsec
Moderator Group Joined: 04 May 2015 Location: USA Status: Offline Points: 4996 |
Post Options
Thanks(0)
Posted: 01 Aug 2017 at 12:26pm |
I assume you are not leaving the two Power Switch pins shorted with something after the board has started? The usual trick to shut off the PC when you are in the UEFI/BIOS, is to press and hold down the power button on the PC case, until the PC turns off. It takes a few seconds holding the power switch down before the board will turn off, but it will turn off. So in your situation, you would need to short the two Power Switch pins and maintain the short circuit until the board turns off. That has the same affect as pressing and holding down the power switch. You could also just turn off the PSU with its switch, but that is not as clean and more abrupt than maintaining a short circuit across the two Power Switch pins. |
|
Andrew
Newbie Joined: 13 Jul 2017 Location: Australia Status: Offline Points: 9 |
Post Options
Thanks(0)
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |