|
X670E Steel Legend BIOS failure |
Post Reply 
|
| Author | |
NDRE28 
Groupie 
Joined: 08 Sep 2024 Location: Romania Status: Offline Points: 620 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: X670E Steel Legend BIOS failurePosted: 17 Oct 2024 at 10:41pm |
|
It's a good practice to disable the fTPM module before a BIOS update.
|
|
 |
|
|
Skybuck
Senior Member 
Joined: 18 Apr 2023 Status: Offline Points: 1215 |
Post Options
Thanks(0)
Quote Reply
Posted: 17 Oct 2024 at 8:12pm |
|
Most likely boot error, in this case boot sector might be corrupted, could also have something to do with trusted platform module stuff.
What you could try is enter repair mode somehow from windows. Then run this command to restore boot sector: bootrec/ fixmbr bootrec/ fixboot bootrec/ scanos bootrec/ rebuildbcd |
|
|
|
|
NDRE28
Groupie
Joined: 08 Sep 2024 Location: Romania Status: Offline Points: 620 |
Post Options
Thanks(0)
Quote Reply
Posted: 15 Oct 2024 at 4:39am |
Hello! I'd try reflashing the BIOS, with the new BIOS version, again. If you can still access the BIOS menu, then it's not that bad. TAKE THESE STEPS: 1. Use another computer, and download BIOS 3.08. 2. Then copy it on a FAT32 formatted USB flash drive. 3. Insert the USB flash drive in a legacy port (USB 2.0, or 3.0). 4. Power on the PC. Go to Boot section and select as the first boot device your USB flash drive. 5. Save (F10). Restart PC. 6. Enter in the Q-Flash mode (press key F11 or End) and update the BIOS again. Tell me if it worked! |
|
|
|
|
Bordzik
Newbie 
Joined: 14 Oct 2024 Status: Offline Points: 20 |
Post Options
Thanks(0)
Quote Reply
Posted: 14 Oct 2024 at 8:31pm |
|
Hello everyone, I'm new here. Recently I bought new PC, specs are as follows:
Ryzen 7 7800X3D RTX 4070 Ti SUPER ADATA Lancer Blade 32 GB 6000Mhz Kingston KC3000 My BIOS was by default in version 2.02. I wanted to update it, first by Instant flash, but while updating my PC instantly shut down. Then I read that with my GPU it is recommended to use iGPU while updating BIOS. It was probably the cause of failure. I didn't do it anyway, and tried to update BIOS by Flashback. The green LED was blinking and then it was off, I assumed the BIOS updated succesfully. PC booted, I could access BIOS and it was updated to the newest version (3.08). I closed BIOS, but I cannot access Windows (11 Home), code 0xc00000e. PC runs for about 4-5 minutes and again shuts down, like when I tried to update it first. Does it mean that I fcked up my motherboard? Is it possible to rollback to older version (2.02) of BIOS? Any advice would be useful, thanks. |
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options
Bordzik wrote: