Taichi X670E Manual Shortcomings

Perhaps this is nearly meaningless to mention but the Taichi X670E manual is extremely detailed, with several images, and perspectives on many of the components, especially the CPU installation (pp. 15-17).

However, there is no explicit reference to powering the CPU through the two ATX 12V 8-pin power connectors.

Some individuals, like myself, might assume the CPU is powered through the ATXPWR1 connection.

It took me hours to realize what I might have overlooked, and I took the computer to a shop just to be certain before anything was plugged in.

There is a poorly worded implication/suggestion/warning on p. 49, "Warning: Please make sure that the power cable connected is for the CPU and not the graphics card." And there is an image on p. 36: 2.9 Connecting the Power Connectors. But these are the only two references to powering the CPU.

Notwithstanding this minor shortcoming (minor for some), the manual is excellent.

Thank you, I appreciate your response. I have not built a computer since 2015, and I forgot some of the basics.

Just as a humorous side-story: I installed the Taichi into a Thermaltake Core X71, and coincidentally, there is a screw position that requires a standoff that was not pre-installed.

Naturally, I didn't realize this until after I installed every other screw. I subsequently decided to leave the space empty believing it would make no significant difference.

It was my terrible luck that this particular screw position is precisely the screw position shown in the example on page 30, "2.5 Installing the Motherboard."

And after the board failed to boot, looking for a cause, I thought to myself, "Why are they explicitly pointing out this screw position? Is it an essential ground?"

I even started questioning the drawing of the screwdriver tip, "What is that tool, is that a Phillips head screwdriver, or a pen, or is it a universal symbol of importance, like 'This particular screw must be screwed in?'"

I just have to laugh now. That image puzzled me, only because the motherboard failed to boot, and the drawing didn't look anything like a screwdriver that I ever used.

I'm not nitpicking, I'm not critiquing, I just think it's a funny side-story that also cost me a couple extra hours. :DD