asrock b550 taichi (not Razer) ARGB problems |
Post Reply |
Author | |
ezflip
Newbie Joined: 26 Dec 2015 Status: Offline Points: 29 |
Post Options
Thanks(0)
Posted: 28 May 2024 at 7:51pm |
Hello all,
I have recently installed a b550 taichi mb (not razer ver.) into a Corsair D5000 Flow case. Installed 3 corsair SP120 Elite rgb fans in front and 1 in the rear. They are connected to a hub that handles pwm + argb. I know it's argb because of the 3 pins connector. From the hub, 1 wire connects to the pwm header on the mb (that's fine since the fans spin) the other wire goes to the argb header. Power is from a Sata connector. I've tried both argb headers (top and bottom one) but the fans don't light up. iCue software doesn't see the fans and asrock software doesn't see them as well. I've tried installing a fresh version of both software with many reboots and much hair pulling but no success. I would love to read a solution to this issue before deciding to ditch the fans and replacing them with others but I fear that I would run into the same problem again. Thanks for your time. |
|
johnukguy
Newbie Joined: 07 Jun 2024 Location: USA Status: Offline Points: 120 |
Post Options
Thanks(0)
|
Have you tried the RGB settings available in the BIOS?
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |