Installing Win10 on Z170 Extreme4

Hi there, folks.

Here's the problem. I currently have win10 laptop, so i created bootable usb with MediaCreationTool, FAT32.

And when Im trying to boot it from totally clear pc, UEFI doesn't recognize flash. In case if I clear CMOS, it sees this flash as USB 3.0 or UEFI 3.0, Partition 1.

Both doesn't work, because when i go force boot from the usb stick, it looses it after reboot and asks to select proper boot device. To make UEFI see usb-stick again, I have to clear CMOS one more time.

Also, if I pass these steps, windows installer asks for missing media drivers.

Secure and Fast boot disabled, CSM enabled and legacy setting only.

When you used the media creation tool did you select 32, 64 or both?

>> Here's the problem. I currently have win10 laptop, so i created bootable usb with MediaCreationTool, FAT32.

What is Win 10 laptop? Home 32/64 or Pro 32/64?

If you are using a front panel port or hub,...don't. Also disconnect all other usb devices and use a rear motherboard usb port.

Use the "UEFI 3.0, Partition 1"