Your Kingston memory is compatible with your CPUs and board, and you have four DIMMs, so you can use two for each CPU. The G.SKILL memory is not in the QVL list. Use the Kingston.

You have both CPUs in the board, correct?

Your video shows cables to both CPU power connectors, I can't tell if the cable is correct or not. Be sure not to use the PCIe power cables for the CPU power.

Both videos shows the G.SKILL memory, try using the Kingston again. Clear the BIOS before starting the board again after inserting the Kingston memory.

You can try using only one DIMM for each CPU at first, inserted in one of the blue slots farthest from the CPU socket. Or two DIMMs, again in the blue sockets farthest from the CPU.

The POST codes shown, which sequence through each CPU and memory set, were memory errors, but that was with the G.SKILL memory.

Hi!

Yes. Everything seems to be working perfectly now.

jannekalle wrote: My build won't start to BIOS (no video). I've tried with two types of memory and monitor is plugged to the VGA output of Mobo...  Here's a link to Dr. Debug https://youtu.be/onykSkCwdPg I've got nothing connected besides 2 x CPU (Xeon-e5 2670 v1). Could it be the Mobo or the PSU or have I just forgotten something important?!  Thanks in advance! EP2C602-4L/D16 2 x XEON e5 2670v1 Corsair RM1000x (PSU)

NM the two SLI'd GTX 980ti's

Us Mods must get better at asking for system specs at time of troubleshooting/diagnosing.

Hi, just to add my experience to this:

I built a system with the same MB, two HyperX FURY 8 GB DDR3 1866 MHz, and a Gigabyte NVIDIA GTX 750Ti 2GB PCI-E GPU (just to get an HDMI port).

When I powered the system up, I got nothing at all except a green LED on the MB just below the power connector, and another flashing by the PCI slots -- no fans, nothing on either video out.

Removing the GPU made the MB power up normally, and I was able to run it via the VGA output.  I tried this several times while messing with the PCI settings in BIOS (e.g. changing the PCI version to 3, and back to 2), and it was totally consistent -- GPU in, dead as a doornail; GPU out, worked fine.

I rushed out to PC World and got an Asus GT710 GPU, and it works fine.  So I guess this MB isn't compatible with some GPUs.  Ouch.

My next problem was random crash / reboots, which was apparently due to Windows 10 -- it seems it's not compatible.  I'm now running Linux which is fine.  I've heard Windows 7 works fine too.

All the best!