AGESA 1.0.0.6a

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

 AGESA 1.0.0.6a
This took some tweaking but it works the best for me so far!ASRock X370 Taichi : AGESA 1.0.0.6a
CPU CORE 1.376 V
VPPM 2.544 V
AVCC 3.344 V
3VCC 3.344 V
+12V 12.038 V
VDDCR_SOC 1.104 V
DRAM 1.360 V
VIN7 0.752 V
VDDP 0.992 V
+1.8V 1.824 V
VIN11 1.272 V
+5V 5.016 V
Chipset +1.05V 1.104 V

AMD Ryzen 7 1800X : Multiplier x40.0 = 4000.5 MHz 100% stable
RAM : G.SKILL TridentZ RGB Series 32GB (4 x 8GB) 288-Pin DDR4 SDRAM DDR4 3866 (PC4 30900) Desktop Memory Model F4-3866C18Q-32GTZR    
Where I'm at with it =          
32.0GB Dual-Channel @ 1733.5 MHz - Ratio 3:52 (3467 MHz)
Total memory slots 4
Used memory slots 4
Total Physical 32 GB
CAS# Latency               (CL) 18 clocks
RAS# to CAS# Delay (tRCD) 18 clocks
RAS# Precharge          (tRP) 18 clocks
Cycle Time                (tRAS) 38 clocks
Bank Cycle Time         (tRC) 56 clocks remember TRC SHOULD BE TRES + TRP TO be in sync!
Command Rate            (CR) 1T

For ram had to set in bios PROC to 48 and voltage to 1.38
Also I have found if you change anything in bios the CPU Multiplier needs to be raised and lowered and then set back to your setting or else it will not hold
Say for me it is running at 40 so every time I mess with memory I have to raise and lower then put back to 40 then save or else the Multiplier will show 40 in bios but will not run at 40
It will run at factory setting and just visually show 40 (4000mhz) in bios!

Edited by CJG - 21 Jul 2017 at 8:25am