![]() |
Bricked X470 Taichi? |
Post Reply ![]() |
Page 12> |
Author | |
cx5 ![]() Senior Member ![]() Joined: 15 Sep 2017 Location: Hong Kong Status: Offline Points: 2398 |
![]() ![]() ![]() ![]() ![]() Posted: 12 Jul 2019 at 2:58pm |
x370 taichi only 128Mb,hope enough to support till Ryzen 5000, 6000 or 7000 hahahahahah |
|
x370taichi@3.50gen4
AX750 Optane900P SN770 3800x PosdonZro4 BarrowPWM-17w>420x140x28 XFX SWFT319 6900XT MSI RX560 LP to get Fluid Motion BlueskyFRC 75hz |
|
![]() |
|
gizmic ![]() Groupie ![]() ![]() Joined: 13 Jun 2018 Location: Hong Kong Status: Offline Points: 677 |
![]() ![]() ![]() ![]() ![]() |
taichi are 256Mb youre mixing with the msi problem
|
|
![]() |
|
![]() |
|
AsRx470Tc ![]() Newbie ![]() ![]() Joined: 09 Jul 2019 Location: Finland Status: Offline Points: 33 |
![]() ![]() ![]() ![]() ![]() |
32GB memory kit XMP also OK. All four dimms (48GB) at 3200MHz XMP also OK.
Funny enough, when i was updating my bios with that Ryzen3, all bios versions up to the re-released 3.43 version showed up. I went with 3.40. But now with my 3600X version 3.43 doesn't show up, only up to 3.40. Thankfully i didn't go straight to that version, might have another 00 debug code issue on my hands now... |
|
![]() |
|
AsRx470Tc ![]() Newbie ![]() ![]() Joined: 09 Jul 2019 Location: Finland Status: Offline Points: 33 |
![]() ![]() ![]() ![]() ![]() |
Finally that R3-1200 arrived, and so did my first 3000 series chip, an R5-3600X.
Still waiting for a R7-3800X. Bios updated without a problem with that R3-1200. Now running that R5-3600X without problems (about 15mins so far). My 16GB(2x8GB) 3200MHz kit of HyperX Predators running at max XMP no problem. Still have a 32GB(2x16GB) kit of the same memory, not tested it yet. |
|
![]() |
|
AsRx470Tc ![]() Newbie ![]() ![]() Joined: 09 Jul 2019 Location: Finland Status: Offline Points: 33 |
![]() ![]() ![]() ![]() ![]() |
Yeah, there are propably some limitations on that. Memory space on a tiny bios chip is quite limited. Thankfully the store accepted the first board for an RMA, told them the same story as i told here. Just dropped it off in the post office. Now just waiting for that Ryzen 3. It has been shipped out from the other place today. |
|
![]() |
|
kschendel ![]() Newbie ![]() Joined: 21 Aug 2018 Status: Offline Points: 86 |
![]() ![]() ![]() ![]() ![]() |
I think pre-Ryzen support had to be dropped to fit the 3000 series support in, which might be why you aren't getting anywhere with post-2.0 BIOS. With any sort of luck, the 1200 will do the trick.
|
|
![]() |
|
gizmic ![]() Groupie ![]() ![]() Joined: 13 Jun 2018 Location: Hong Kong Status: Offline Points: 677 |
![]() ![]() ![]() ![]() ![]() |
make sure its a .bin file
|
|
![]() |
|
![]() |
|
AsRx470Tc ![]() Newbie ![]() ![]() Joined: 09 Jul 2019 Location: Finland Status: Offline Points: 33 |
![]() ![]() ![]() ![]() ![]() |
Yeah, that was already known. There were "slight" problems doing so, as stated in the op. |
|
![]() |
|
AsRx470Tc ![]() Newbie ![]() ![]() Joined: 09 Jul 2019 Location: Finland Status: Offline Points: 33 |
![]() ![]() ![]() ![]() ![]() |
I have a Ryzen 3 1200 CPU on the way now (cheapest ZEN architecture chip there was available asap), will test with that on the 2nd board. Will post my results here in 1-2 days if there is no delays with the shipment. For the 1st board... not looking good :D |
|
![]() |
|
gizmic ![]() Groupie ![]() ![]() Joined: 13 Jun 2018 Location: Hong Kong Status: Offline Points: 677 |
![]() ![]() ![]() ![]() ![]() |
you can only update to 3.XX using the bridge bios 2.00
|
|
![]() |
|
![]() |
Post Reply ![]() |
Page 12> |
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |