ASROCK B450M Pro 4 Memory Configs

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Hi,

Recently I bought a B450M Pro 4 to replace my old mother board. Unfortunately whenever I load the XMP Profile, my pc reboots after every few mins on normal use.

I'm using cmk8gx4m1d3000c16 sticks in duel channel mode on A1 and B1 slots cause those are the only slots the motherboard boots in. On disabling XMP this issue does go away.

My specs are
B450M Pro 4
AMD 3500 (Matisse)
Corsair VENGEANCE LPX 8GB (2x8)
Corsair TX650M PSU
Geforce 750 TI

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Alcatraz Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 16 Oct 2021 Location: Mumbai Status: Offline Points: 35	Post Options Post Reply Quote Alcatraz Report Post Thanks(0) Quote Reply Topic: ASROCK B450M Pro 4 Memory Configs Posted: 17 Oct 2021 at 1:08pm
	Hi, Recently I bought a B450M Pro 4 to replace my old mother board. Unfortunately whenever I load the XMP Profile, my pc reboots after every few mins on normal use. I'm using cmk8gx4m1d3000c16 sticks in duel channel mode on A1 and B1 slots cause those are the only slots the motherboard boots in. On disabling XMP this issue does go away. My specs are B450M Pro 4 AMD 3500 (Matisse) Corsair VENGEANCE LPX 8GB (2x8) Corsair TX650M PSU Geforce 750 TI
	kyelve

MadScientist Members Profile Send Private Message Find Members Posts Add to Buddy List Groupie Joined: 17 Aug 2020 Location: TN Status: Offline Points: 483	Post Options Post Reply Quote MadScientist Report Post Thanks(0) Quote Reply Posted: 17 Oct 2021 at 8:15pm
	Boot to your bios and under OC Tweaker manually input your ram settings. https://www.corsair.com/us/en/Categories/Products/Memory/VENGEANCE%C2%AE-LPX-8GB-%281-x-8GB%29-DDR4-DRAM-3000MHz-C16-Memory-Kit---Black/p/CMK8GX4M1D3000C16#tab-tech-specs Dram Frequency 3000 Infinity Fabric clock speed (FCLK) 1500 Voltage 1.35V Latency settings 16-20-20-38 If still have problems with reboots increase the voltage to 1.36V For dual channel mode you should be using slots A2 and B2. In dual channel you should be using slots A2 and B2.

Alcatraz Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 16 Oct 2021 Location: Mumbai Status: Offline Points: 35	Post Options Post Reply Quote Alcatraz Report Post Thanks(0) Quote Reply Posted: 17 Oct 2021 at 9:05pm
	Thanks but another solution worked. The issue was with the XMP Profil & RAM slots apparently, if I use A1 & B1 without XMP enabled my pc runs fine but after switching it on. I have switch RAMS to slot to A2 & B2. If I switch off XMP I have to physically again switch them to A1 and B1 or use one stick of RAM.
	kyelve