ASROCK 970 PRO3 R2 RANDOMLY 5 BEEPS

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Hi guys,

i have a full assembled pc with an ASROCK 970 PRO3 R2. 
Everything goes fine. Since not much time(it did some time in the past yet but not a lot), it start randomly, when i boot on the pc, to beeps 5 times and dotn give any input on screen.
So everytime i just change the opposite input of the HDMI cable and it turn on with any problems.
What could be?
Also, sometimes after it boot on, when im on windows it freeze and i have to reboot it. In add, after some time,turn on and reboot automatically, then it start to goes fine...
Its a motherboard problem for everything? 

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Ael3urt Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 30 Jan 2023 Status: Offline Points: 35	Post Options Post Reply Quote Ael3urt Report Post Thanks(0) Quote Reply Topic: ASROCK 970 PRO3 R2 RANDOMLY 5 BEEPS Posted: 30 Jan 2023 at 9:35pm
	Hi guys, i have a full assembled pc with an ASROCK 970 PRO3 R2. Everything goes fine. Since not much time(it did some time in the past yet but not a lot), it start randomly, when i boot on the pc, to beeps 5 times and dotn give any input on screen. So everytime i just change the opposite input of the HDMI cable and it turn on with any problems. What could be? Also, sometimes after it boot on, when im on windows it freeze and i have to reboot it. In add, after some time,turn on and reboot automatically, then it start to goes fine... Its a motherboard problem for everything?

Xaltar Members Profile Send Private Message Find Members Posts Add to Buddy List Moderator Group Joined: 16 May 2015 Location: Europe Status: Offline Points: 25073	Post Options Post Reply Quote Xaltar Report Post Thanks(2) Quote Reply Posted: 31 Jan 2023 at 1:19am
	You could try another HDMI cable, it could be faulty or have dirty/corroded contacts. The 5 beeps just means the PC didn't detect your monitor. The freezing and reboot issues you mentioned are likely unconnected.


Ael3urt Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 30 Jan 2023 Status: Offline Points: 35	Post Options Post Reply Quote Ael3urt Report Post Thanks(0) Quote Reply Posted: 31 Jan 2023 at 4:51am
	What could be about them?

Xaltar Members Profile Send Private Message Find Members Posts Add to Buddy List Moderator Group Joined: 16 May 2015 Location: Europe Status: Offline Points: 25073	Post Options Post Reply Quote Xaltar Report Post Thanks(1) Quote Reply Posted: 31 Jan 2023 at 11:05pm
	Freezing and crash/reboot issues are 2 of the most common issues in tech. They could be caused by anything from a bloated operating system to bad drivers to hardware failure. The best place to start is to scan for malware, viruses and spyware. Check the inside of your PC for dust etc. If it's very dusty/dirty you can use a can of compressed air to blow out the dust and be sure to pay particular attention to the CPU cooler and graphics card heatsinks.