H270 fatal1ty boot problem

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Hello,
I have H270 fatal1ty that works at home with i7 6700 and 16GB of ram, nvme and so on.
Cuz I have one more bord like this that frind gived to me long time , i try to start it, but it goes to reboot loop all the time.
I have try to clear the CMOS, swiched the CPU, also swiched the RAM, try to start is without and GPU, and still same. I dont know what to try more.
Can you please give me an advice what to try to do with this MB.

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
ResedentMan Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 28 Mar 2023 Location: Burgas Status: Offline Points: 20	Post Options Post Reply Quote ResedentMan Report Post Thanks(0) Quote Reply Topic: H270 fatal1ty boot problem Posted: 28 Mar 2023 at 11:27pm
	Hello, I have H270 fatal1ty that works at home with i7 6700 and 16GB of ram, nvme and so on. Cuz I have one more bord like this that frind gived to me long time , i try to start it, but it goes to reboot loop all the time. I have try to clear the CMOS, swiched the CPU, also swiched the RAM, try to start is without and GPU, and still same. I dont know what to try more. Can you please give me an advice what to try to do with this MB.

Xaltar Members Profile Send Private Message Find Members Posts Add to Buddy List Moderator Group Joined: 16 May 2015 Location: Europe Status: Offline Points: 18323	Post Options Post Reply Quote Xaltar Report Post Thanks(0) Quote Reply Posted: 29 Mar 2023 at 3:09am
	Try a single stick of RAM in slot A2 Only the CPU installed, no SATA cables or USB devices connected (except for a keyboard) Make sure the CPU power (8pin) and main power (24pin) are properly connected Power on the system and leave it running for 10mins or more to rule out slow RAM training If you still don't get a POST screen then try pulling the CMOS battery, disconnect the system from power and hold the power button for 3 - 5 seconds. Leave it like this for an hour or so (just to be sure) and try booting again. Failing that, check the CPU socket for bent pins and look over the board for any bent over component legs (on the back of the board) that may be shorting. Good luck.