EP2C602 Smbios Firmware processor component error |
Post Reply |
Author | |
darlingm
Newbie Joined: 14 Sep 2016 Status: Offline Points: 4 |
Post Options
Thanks(0)
Posted: 14 Sep 2016 at 11:38am |
AsRock Rack EP2C602
Dual Xeon E5-2690, Noctua NH-U12DXi4 fans (8x8GB) 64GB DDR3 Corsair RM1000X Power Supply NOTHING else, just doing a general POST test. (Some other parts haven't arrived.) System turns on and navigates BIOS just fine. Under Event Logs -> View smbios Event Log, it shows 3 entries timestamped as of its first POST. The first is a log area reset, the second is a chassis secure switch activated. It's the THIRD that I'm writing about: EFI 00021002 Minor DESCRIPTION Firmware processor component encountered a communication error. I can't find anything about what this means, if it's a problem, or what it indicates might be bad. |
|
wardog
Moderator Group Joined: 15 Jul 2015 Status: Offline Points: 6447 |
Post Options
Thanks(0)
|
I believe if you place a graphics card in her you'll find this will subside.
|
|
darlingm
Newbie Joined: 14 Sep 2016 Status: Offline Points: 4 |
Post Options
Thanks(0)
|
Wasn't planning on adding a graphics card, it's a non-graphical linux server. Is this an error that can be safely ignored? Or is something off with the integrated graphics?
|
|
wardog
Moderator Group Joined: 15 Jul 2015 Status: Offline Points: 6447 |
Post Options
Thanks(0)
|
Scour the logs for EDAC and or mpc85xx .
Also, dare I ask what kernel? https://sourceforge.net/p/bluesmoke/mailman/message/27294291/ Bluesmoke > EDAC > finally mainstream kernel http://bluesmoke.sourceforge.net/ |
|
snakedogman
Newbie Joined: 27 Oct 2016 Status: Offline Points: 1 |
Post Options
Thanks(0)
|
Hi,
I recently built a system very much like yours (many people seemed to be inspired by the "32 thread monster PC" article ;)) and I see the same log message in my UEFI. I have installed a Geforce GTX970 Graphics card. Running Windows 10 here. No idea what it means. Do you also have the issue that the system sometimes needs to go through the initial boot phase several times before starting the OS? Mine does this, ie start up the PC, after a couple of seconds I get the Asrock logo, then it goes black again (doesn't turn off) and then again the Asrock logo. Usually after the third time it boots to Windows just fine. Sometimes it boots to Windows immediately. I wondered if it was related to these log messages. |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |