Z170 Pro4s - Fan control?

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   I have the same board and it seems CHA_FAN3 runs at full speed all the time, A-Tuning won't let me adjust it (it does not even show up). It may be that the header is designed for full power use only, the manual does not say. Happy to see you found a solution 
I just put a limiter on the fan I use on that header, for me it isn't an issue as all my fans are low noise 140mm fans. The Z170 Pro4s is a great little board 

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Xaltar Members Profile Send Private Message Find Members Posts Add to Buddy List Moderator Group Joined: 16 May 2015 Location: Europe Status: Offline Points: 24713	Post Options Post Reply Quote Xaltar Report Post Thanks(0) Quote Reply Topic: Z170 Pro4s - Fan control? Posted: 15 Nov 2016 at 2:25pm
	I have the same board and it seems CHA_FAN3 runs at full speed all the time, A-Tuning won't let me adjust it (it does not even show up). It may be that the header is designed for full power use only, the manual does not say. Happy to see you found a solution I just put a limiter on the fan I use on that header, for me it isn't an issue as all my fans are low noise 140mm fans. The Z170 Pro4s is a great little board


zhollett Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 15 Nov 2016 Status: Offline Points: 4	Post Options Post Reply Quote zhollett Report Post Thanks(0) Quote Reply Posted: 15 Nov 2016 at 1:45pm
	Well, that was quick. I had the radiator fan plugged into CHA_FAN3 because the wires were short. That fan controller is a 3 pin, and the Radiator fan is a 4 pin. I extended the wires so I could plug the Radiator fan into CHA_FAN2, and it's working perfectly now. Still PWM should be able to control on CHA_FAN3, but oh well. My system is quiet, that's all I care about.

zhollett Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 15 Nov 2016 Status: Offline Points: 4	Post Options Post Reply Quote zhollett Report Post Thanks(0) Quote Reply Posted: 15 Nov 2016 at 1:25pm
	Hello, As the title says I have the z170 Pro4s motherboard with the i5 6600k (non o/c). I have a Corsair Case with 1 chassis fan. I have the H60 Water Cooler which has the pump and a radiator fan. My problem is there appears to be no way I can control the fans. They are running very high, but my temps are extremely low. Currently I am at 24c/36c and the fans are still running high. I have this system in my media room and it is annoying while watching movies. I have downloaded the A-Tuning and no matter what fan profile I apply, the fans never change speed. The fans are all 3 wire. Is there any way I can control these fans? Help would be greatly appreciated. Thanks.