z370 Taichi & 8700k Advise

If you can handle to translate a bit from russian language: 

Globespy wrote: I know this is an old post, but you should have been able to achieve that 5ghz with ease unless of course you seriously lost the 'silicon lottery'. It should be simply going into the BIOS advanced section, then the OC Tweaker area. Disable MCE, choose base clock on 'All cores', set the first 2 values to 50, then the min value just leave at 42. Go into voltage settings and choose 'fixed' voltage and try 1.35V to start with, then save and exit BIOS. If Windows boots then try running RealBench stability test. If it passes then you could try to lower your voltage to 1.34v, then rinse and repeat. If it's stable at 1.34v then you are finished.  If it fails at 1.35v within seconds or a few minutes of starting the stress test then try 1.37v and test again. You can do this all the way to 1.4v which many consider the max for a 24/7 Coffee-lake CPU - personally I think much of this is from 'old timers' who keep spreading misinformation. These chips love current and intel rates their max vCore at 1.52v, which is likely conservative if you consider the legal ramifications. Would I want to run at that 24/7? No. But 1.4-1.42v for a stable 5ghz if you are on AIO water or good air cooler (Noctua NH-D15) is fine for 24/7 OC assuming your general task temps (gaming, productivity, video rendering) are below 80-85C. I have yet to hear of a Skylake, KabyLake or CoffeeLake chip die due to voltages in the low 1.4v range. I still have an i7 6700k that runs 24/7 at 1.45v for close to 3 years without issue. I game on PC, so 4 years is usually about my limit before the hardware starts to become 'tired' and out of date. But I bet these chips would go 10 years without any trouble unless there's a manufacturing flaw that causes failure and that would usually happen sooner than later.

Thank you very much for the advice. I did as you said and was able to get stable 5.0 GHZ@ 1.328. After getting stable I adjusted it too offset and all is good.

I did have to adjust the cache setting from 50 to 45 and did not play with to much after.

The rest of the volts are on AUTO. Any of those needs adjusted up or down?

running real bench and prime95 I maxed out around 70C. CPU is delided with a evga clc280.