B650M-HDV/M.2 does not post with 2 ram sticks

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Hi All,

I have the following issue if anyone could help:

I changed mobo, cpu, ram, vga in my pc yesterday and currently have the following:

Asrock B650M-HDV/M.2; Ryzen 5 7600;
RTX 4060;
KINGSTON FURY 32GB Beast RGB DDR5 5600MHz CL36 KIT KF556C36BBEAK2-32 (This is QLV supported)

I assembled the rig yesterday and ran for almost 12 hours without any issue and multiple successful reboots even gaming for hours. I turned it on today and it did not want to post and RAM rgb also did not light up having DRAM and CPU lights glowing red on the board. Since then I realised that it works with only 1 ram stick installed.
I initially switched the RAM profile to EXPO 5600 yesterday and it was working fine. Since then I also defaulted BIOS settings so its back to default 4800 but still not working with both ram modules.

Bios version: 3.06

Any idea that could help would be appreciated. Thanks

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
mzex Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 9 hours 15 minutes ago Status: Offline Points: 35	Post Options Post Reply Quote mzex Report Post Thanks(0) Quote Reply Topic: B650M-HDV/M.2 does not post with 2 ram sticks Posted: 9 hours 14 minutes ago at 8:47pm
	Hi All, I have the following issue if anyone could help: I changed mobo, cpu, ram, vga in my pc yesterday and currently have the following: Asrock B650M-HDV/M.2; Ryzen 5 7600; RTX 4060; KINGSTON FURY 32GB Beast RGB DDR5 5600MHz CL36 KIT KF556C36BBEAK2-32 (This is QLV supported) I assembled the rig yesterday and ran for almost 12 hours without any issue and multiple successful reboots even gaming for hours. I turned it on today and it did not want to post and RAM rgb also did not light up having DRAM and CPU lights glowing red on the board. Since then I realised that it works with only 1 ram stick installed. I initially switched the RAM profile to EXPO 5600 yesterday and it was working fine. Since then I also defaulted BIOS settings so its back to default 4800 but still not working with both ram modules. Bios version: 3.06 Any idea that could help would be appreciated. Thanks

Xaltar Members Profile Send Private Message Find Members Posts Add to Buddy List Moderator Group Joined: 16 May 2015 Location: Europe Status: Offline Points: 25013	Post Options Post Reply Quote Xaltar Report Post Thanks(0) Quote Reply Posted: 6 hours 24 minutes ago at 11:37pm
	Remove and reseat your CPU and CPU cooler. Make sure your mounting pressure is even and not too much, snug down don't tighten down. It sounds like the weight of your cooler + uneven pressure caused the CPU to shift in the socket (lifted a corner or edge) and now some pins aren't making contact. The memory controller is on the CPU and it's typically connected to pins on the edge of the CPU. I hope this makes sense and good luck.


mzex Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 9 hours 15 minutes ago Status: Offline Points: 35	Post Options Post Reply Quote mzex Report Post Thanks(0) Quote Reply Posted: 6 hours 14 minutes ago at 11:47pm
	I will try that, thanks. Note that since then I realised that my memories sometime work after power cycling the pc as in unplgging PSU cable and holding the power button then plugging it back and it works. Although it usually requires multiple cycles. Not sure if that will be fixed with re-seating CPU