Addressable RGB LED (WS2812B)

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Try to flash the LED firmware under Windows:

http://forum.asrock.com/forum_posts.asp?TID=4537&PN=3&title=rgb-led-issues

That should fix the problem. I had a similar issue as well when I first setup the board.

Edited by akirabbq - 07 Jun 2018 at 10:48pm

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
akirabbq Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 07 Jun 2018 Status: Offline Points: 22	Post Options Post Reply Quote akirabbq Report Post Thanks(0) Quote Reply Topic: Addressable RGB LED (WS2812B) Posted: 07 Jun 2018 at 10:47pm
	Try to flash the LED firmware under Windows: http://forum.asrock.com/forum_posts.asp?TID=4537&PN=3&title=rgb-led-issues That should fix the problem. I had a similar issue as well when I first setup the board. Edited by akirabbq - 07 Jun 2018 at 10:48pm

corso Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 22 May 2018 Status: Offline Points: 3	Post Options Post Reply Quote corso Report Post Thanks(0) Quote Reply Posted: 22 May 2018 at 10:43pm
	Hi Guys, I cannot get the addressable RGB LED strip working properly , only one LED work . I have two stripe and the two strip have the same issue. The motherboard is the Asrock x470 Master SLI/ac. I use the polychrome application v1.0.11, if I setup the good amount of addressable LED only one LED light up with the good color, if I set the number to 7 the RGB stripe LED stop working, if I put less than 7 the LED under the chipset stop working too... I have plug a logic analyser on the addressable RGB LED strip. My observation was that only 24 bit of data was send each time. Normaly for this kind of RGB addressable LED it's [24 bit x Number of LED]. So for my case 24 bit x 22 LED = 528 bits of data. So I think that is a software problem... I try bios v1.00, v1.10 and v1.15 without change. Someone of you have I solution for my problem? Thanks ,
	-Corso-