X670E Taichi, 3.0x issue on coldboot

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   I have a X670E Taichi main-board with 3x NVMe and all usable SATA connections utilized.
Ever since the first 3.0x beta BIOSes were released I have the following issue.

I currently have the 3.08 BIOS installed.

On cold boot, 1 of the 3 AMD GPIO devices fails to initialize properly (yellow exclamation mark in the device manager).
It states there weren't enough resources available.

The symptom you immediately notice when you have logged in is that the system tray displays the "usb" icon. All SATA connected drives are now "hot-swap".
(This used to be similar to thunderbolt being enabled in the BIOS (2.xx))

However, when I perform a "warm" reboot and then get back to being logged in. 
The system with the 3.08 BIOS installed is working like it should and all 3 of the AMD GPIO devices have initialized properly. 
Why won't it initialize properly on cold boot????

With the previous official 2.10 BIOS I did NOT experience this issue on Cold boot.

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Tikimotel Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 27 Apr 2024 Location: Netherlands Status: Offline Points: 40	Post Options Post Reply Quote Tikimotel Report Post Thanks(0) Quote Reply Topic: X670E Taichi, 3.0x issue on coldboot Posted: 2 hours 59 minutes ago at 7:16pm
	I have a X670E Taichi main-board with 3x NVMe and all usable SATA connections utilized. Ever since the first 3.0x beta BIOSes were released I have the following issue. I currently have the 3.08 BIOS installed. On cold boot, 1 of the 3 AMD GPIO devices fails to initialize properly (yellow exclamation mark in the device manager). It states there weren't enough resources available. The symptom you immediately notice when you have logged in is that the system tray displays the "usb" icon. All SATA connected drives are now "hot-swap". (This used to be similar to thunderbolt being enabled in the BIOS (2.xx)) However, when I perform a "warm" reboot and then get back to being logged in. The system with the 3.08 BIOS installed is working like it should and all 3 of the AMD GPIO devices have initialized properly. Why won't it initialize properly on cold boot???? With the previous official 2.10 BIOS I did NOT experience this issue on Cold boot.